Recent content by Ploughshares

Thanks much Guy !!!

Friend of mine has a controller box off of a 806b that he wants to power up in order to see if the CIM is working. Does anyone know which pins he needs to attach his power leads to in order to power up the whole box or just the CIM screen ? Thanks much !

I have upgraded my membership. Now how do I place an ad in the Classified section ? Thanks !

Thanks everyone I found a source for front and rear seals. Yes they are pricey !

Does any one know where I can source a Mep 006a rear oil seal ? Part number 3054VG2. Thanks ! Pat

Was able to get the seat compressed and rings out. Now the trick will be to get those tiny rings back in during re-assembly. Also, want to try the " flow method " in order to time the IP. Thanks much to all who weighed in with their suggestions. I do enjoy reading so many helpful comments...

Am in the process of disassembling a M50 injection pump that mounts on a Mep 003a generator. Like others I do not have the " pressing tool " for removal of the plunger retaining rings and seat. Have seen mentioned by others a customized " socket or pipe " tool that works. See in the pump...

You would think someone would have a detailed diagram of wiring a reconnection switch. Have called and searched all over with no luck. Hate to plop down $ 500 - 600 for the complete box when I have a perfectly fine switch. Thanks for your reply.

Am in need of a detailed schematic for wiring a Reconnection Switch on a MEP 002a generator. Was able to obtain an assembly diagram of switch from Electroswitch the fine folks who built the switch. Now have it reassembled . Have looked at several TM's on the generator but none go into much...