Recent content by RandomThinker

So it unthreads or do I just hit it straight on?

Hello, Maybe mine is just stuck but I can't find any videos or info on how to disassemble the driveshaft itself. The grease seal on the telescoping spline of the driveshaft looks beat to $h**. I ordered a new one and have the driveshaft off the truck but cannot figure out how to pull the two...

Will do! It will be another week or so probably.

Thanks guys. I found out the brakes are an FMSI 4615D size (stamped on the side). It looks like these specific pads have been modified to have that little semi-circle cutout for inserting feeler gauges. Otherwise they appear the same. I ordered a set of that size off eBay and they seem to match...

Hello, Does anyone know of commercial equivalents to the LMTV brake shoes? The ones for sale online seem to be way overpriced compared to similar sized commercial equivalents. Right now to swap brakes using the part numbers in the TM is going to run $800. Any help appreciated. So far I have...

Probably dumb question but what oil did you use?

Getting ready to install mine most likely sometime next week. Has anyone done it yet and have pictures of the steps? It seems pretty cut and dry but pictures are always useful for reassurance.

Can you send me a msg for shipping to 07718? Can't send you anything because I'm "new".

What's the ETA for a set to a 4x4? Tentatively interested.

Thanks!

Plasa can you shoot me a PM? The forum isn't allowing me to send you one for some reason.

MME seems to have them and so do a few others. Try searching "thermal resistor" Alternates: QS11902SS, QS-1190-2SS, QS11913SS, QS-1191-3SS, 12421340, 5905-01-440-7331

Ahh ok that makes sense. Thanks

I'm scratching my head and hoping someone can enlighten me. According to the lmtv schematics I only see three sensors for the coolant system. They are shown in zones A-C57 on sheet 7. They are listed P36, P37, and P41. However on my truck I have four sensors, one of which is labeled P12 (or P42)...

Yea I'm waiting for my crowfoot wrenches to come. Hopefully they make it.