-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Ray70's latest activity
-
RRay70 replied to the thread What did I find in the bottom of my MEP?.Looks unrelated to your 802. I don't think I've ever seen anything like that anywhere in an 802 , unless it came from inside the fuel...
-
RRay70 replied to the thread 803A droop adjust screw?.The oil light should stay off above 18 PSI, but the gage is not the determining factor and could be inaccurate. There is a pressure...
-
RRay70 replied to the thread 803A droop adjust screw?.Did you notice any fault lights on while the solenoid was trying to shut it down? If there is a fault found, the relay will kill power...
-
RRay70 replied to the thread MEP-802A questions.There is no need for a vapor barrier on an outdoor slab. In fact, some say it can cause problems outdoors by trapping moisture from...
-
RRay70 replied to the thread MEP-802A questions.Shouldn't have the remesh wire touching the form, it should be fully encapsulated in the concrete, 2" min away from the form, but.. this...
-
RRay70 replied to the thread 803A droop adjust screw?.I think you may have 1 pump adjusted differently than the others, causing the rack to stop short of the screw and holding the other...
-
RRay70 replied to the thread 803A droop adjust screw?.Once you have all 4 pumps oriented correctly test it again. If you still have the same problem, loosen the jam nuts on the stop screw...
-
RYou want them as close to the pushrod tubes as you can make them go... but uniformly across all cylinders.
-
RRay70 replied to the thread MEP-802A questions.Almost... I believe Mainsail bolted the lower blocks to the pad then lagged the upper block through the frame and into the lower blocks...
-
RRay70 replied to the thread MEP-802A questions.
-
RRay70 replied to the thread 803A droop adjust screw?.That's helpful information! Previous posts kind of sounded like the solenoid action was delayed after turning off S1 but was the...
-
RRay70 replied to the thread 803A droop adjust screw?.The solenoid has 3 wires. A black common and 2 colored inputs, 1 from the cranking relay and the other from the malfunction indicator...
-
-
RRay70 replied to the thread 803A droop adjust screw?.Because something is wrong with the 10K ;) Seriously, both should act identically. There should not be any delay and there should be...
-
RRay70 replied to the thread 803A droop adjust screw?.Either way, E- stop or S1, killing power to the fuel solenoid, causing its plunger to spring forward, pushing the rack forward rotating...
-
RRay70 replied to the thread Mep-003 donor engine.Good work getting it going again! In the video I could briefly see the volt gage, which looked to be way above 240V ( assuming you have...
