Recent content by robert248

Thanks I'm going to power down and read!

Started the test today at 1:30pm. Been running for just under 30 minutes. So far so good. Question: any reason the temperature gauge is a little on the higher end or could this be normal? Also am I reading right that the percent rated current just over 50 should be there? I have the heater at...

Here is a short clip of it running. Had to zip the file in order to upload it.

Finally got it running today. This is a snapshot of when it was running. Only ran it for less than 3 minutes. All of the gauges seemed to be working. Panel lights work. Where should I start from here to make sure the generator is working as it should. Is there a section within the manual I...

Thanks! That's what I thought but just wanted to get confirmation. Yes, the hose is connected as you describe. Letting the blue gasket maker cure then I'll advance forward. Appreciate all the help!

When putting it back together does this need to stay open or closed?

What does this need in terms of lubricant if any?

These wires came off and I don't remember which went where. Does it matter when I go to reconnect them? Also on the gasket there should be two of these right? I'm looking at the diagram and its listed in the documentation as #15. Do I just pull hard to remove the metal piece that has the gasket...

Unfortunately I don't have time to wait for gaskets so here goes making my own. Hand tightened the screws and now letting it dry for 30 minutes. Will come back shortly to tighten. Update: The gasket set but letting it sit for 24 hours. Will update after its fully set. Need some help with where...

What is your opinion on changing out the gasket by making your own with this stuff...

I went ahead and cleaned it in the sand blaster. Came out looking great.

Also had a leak here. All my tools are too wide to fit in this area. Any suggestions for tool that is narrow and can fit here?

The water pump was leaking when it turned over so having to replace some gaskets including this one I cant find the part number.

Does anyone know what part number is this gasket?

Where did you source the weather resistant outlet from?