Recent content by Socommfg

  1. Socommfg

    heavier alternative to the MT654CR

    It will be a direct fit bit you will need to add the trans selector as the 3500's are electrical shift.
  2. Socommfg

    Looking for a place to buy LMTV or Deuce axles around Tennessee

    I have low mile LMTV set and tires. 800-648-7687 ernie
  3. Socommfg

    M977 HEMTT radiator

    Seco has the radiator not Socommfg. I have LMTV equipment.
  4. Socommfg

    Wrecker control unit for LMTV 1089 Wreckers.... winchs/stinger/fold/extend etc.

    There are no Patent problems on these controls. We use a better wire and waterproof the connectors. One of the cables we use is R/F and Crush proof.
  5. Socommfg

    Wrecker control unit for LMTV 1089 Wreckers.... winchs/stinger/fold/extend etc.

    I make custom cable for different equipment. The steel case would be a PIA to mfg'er. A aluminum case would be easier and give the switching more protection. The steel case tend to rip the cover off.
  6. Socommfg

    Wrecker control unit for LMTV 1089 Wreckers.... winchs/stinger/fold/extend etc.

    I have had a request to manufacture a Wrecker Control unit for the 1089 wreckers. Before getting into running down all of the parts that are needed I would like to find out what the level of interest is. These will be made in new aluminum cases, unlike the original steel box. Final cost...
  7. Socommfg

    Humvv paper work

    Here is some info that I was working with on importing Ferrets and the Humvv got mentioned along with "Off Road" designations.
  8. Socommfg

    I have joined the club ! And yes I have lost my mine !

    Step Where did you find the steps? Looks great!
  9. Socommfg

    where to post non vehicle items

    Is there a Iron Planet rep on these boards. If so, how do I contact him? thx
  10. Socommfg

    recent problem with Wolverine Technologies LLC

    This is a Small World we play in. Bad feedback is a Death Nail.. Best of luck.
  11. Socommfg

    FMTV High Speed Gears

    A LOT more work! Hard and Heavy. Pulling the axles and knuckles are the easiest way. Figure 2 to 3 days, to do the swap and have help, before you start.
  12. Socommfg

    24v to 12v

    Make sure you have a proper ground. You should read at least 24 vdc on the input. Try reading to ground at a different location.
  13. Socommfg

    M1078 LMTV Cab raising

    Call me and lets see if I can help. 800-648-7687 Ernie
  14. Socommfg

    M1078 LMTV Cab raising

    We have some used pumps and selectors.
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks