Recent content by Tarek

The FL-4 front loader is made by Schmidt, not case. Only the rear excavator module is a CASE 580. Unfortunately I haven't been able to find a Scmidt FL-4 parts book, but would be great if someone here does.

Thanks but the solenoids are functioning as intended when supplied with power. They were stuck from sitting for a while but they're not the issue. It's just that they're not getting power from the harness. But I'll keep your recommendation for other gremlins I'm chasing on other vehicles...

I have actually since found a wiring diagram in mine. But apparently my vehicle is a later version than the manuals. It is equipped with electric solenoid valves for the external fuel tank; both supply and return lines. They're functional, but getting power from the harness. All...

Thanks. Yes these are not even a fraction of the manuals, but thanks for trying to help

5 cylinder Mercedes Turbo model I know this vehicle's presence is low on this forum, but I'm hoping someone can help. I found that I have an issue with power not getting to the relays on the external fuel tank, for both supply and return. The tech manual refers to shutting off or opening those...

This is on the FL-4 boom cylinders. I discovered a parts manual issue when I messed up the threads on the rod and rod nut, because the rod wasn't secured enough when I used the big air impact wrench. So I must repair the rod threads and get a new nut. And so the adventure begins. By my...

Don't mean to hijack the thread, but because it's about the loader hydraulic cylinders: I seem to have messed up the the threads on the rod and rod nut, because the rod wasn't secured enough when I used the big air impact wrench. So I must repair the rod threads and get a new nut. And so the...

Hello, I was wondering if you still have access to the M973 SUSV Manuals. I have purchased a few in the past, which were supposed to be a full set, yet none contains wiring diagrams or schematics. So I was wondering if you, or anyone else have the full set. Here's what I currently have: TM...

IN

thank you very much! Yes I’ve been told the same! And that’s the reason why I should address some major physically demanding issues on the unimog now while I have help for the next few days. All hydraulic cylinders are leaking so off to my search for those seals

Thank you so very much for the response and follow up!!! I got in a major car accident the day I sent you the message and I am now just barely recovered, and resuming my life. Thank you again and happy holidays to you!!!!

Thank you all for the pointers. Does anyone know which of the 3 listed NAPA belts is for the hydraulic pump? Thanks in advance