Recent content by tommyd

Mark, Thanks for your input. I actually work for a rather large tube MFG...but to reverse engineer them would be a PITA. In addition, didn't think it would be that hard to re-install. Anyone know what the threads/type of the fittings? Still in the vehicle and haven't checked yet. Was pissed...

Made new oil cooler lines and look and work great. Put everything together and now the tranny cooler line is leaking. Our these still available or will I have to make these too?

Hello, Been searching but not certain if I can buy or make these lines. Part number is 14061345 or the lower aluminum oil cooler tube that goes to the Rad, not block. Replaced the Rad and the bottom line would not break loose. Needless to say it twisted and NFG now.

1985 M1009 Rad Hello All, My rad just **** the bed this am. I checked out the one you called out. LT warranty, AL and pretty cheap. Is that a direct replacement for a stock M1009? All I really care about is all the correct ports. Hopefully, I can get all the additional fittings/lines out...

When the temp light went on, I pulled over and let her cool down. Topped off the fluid and continued home, without the high temp light on. The light never came on again after it cooled down. It was pretty hot out and I was pushing her, hauling 2-3 yards of dirt at highway speeds. Continued...

Thanks to all that offered help! If you couldn't tell already, I was never in the motor pool group, but do like to fix as much as possible myself. I understand that they are two different systems, but I guessed jumped the gun a little. When I noticed smoke coming from the GP resistor and the...

Batteries, cables or starter. Nice tip. Batteries are good. Starter was replaced about 7 months ago. I will have to check the cables, but the smoke coming from the GP resistor is what is bothering me. I have a push button glow plug switch. Normally it makes a click when depressed. Now...

Thanks. Yes, smoke is emitting from the resistor bank. The high temp light did come on yesterday for a while while working her hard. Stopped and let her cool, caped off fluid and she ran like normal up till this AM. This AM, went to start her and it will not turn over at all. Replaced the...

Okay, have smoke now and even I can figure out that is not good. It is coming from the I think the GP module???. Sits on the fire wall directly behind the engine. Whatever it is, thats were the smoke is coming from. Trying to go through the TM's but having a difficult time loading them. Can...

Hello, I believe I have a solenoid issue. Truck ran fine yesterday. Went to start this am and no cranking or clicking whatsoever, but had power on the cluster ie gen lights. The one I took off the truck is a 9F3099. It's apparently from Caterpiller. Went down to NAPA and they gave me a...

Hello, Anyone have one for sale? If not, what is the proper back spacing if I buy new ones?

Thank you. CPF240,Thank you!

Hello all, Have to ask a dumb question. What is the proper way to jump start another vehicle with the 1009 with original wiring? I once hooked up the + to the strip or bus bar and - to alternator bracket. The system seem to be in series, to me, and was apprehensive to try via terminals...

Starter to support bracket bolt I have a new DB electric gear reduction starter and the bolt was 1/4-20. PITA to get in but done. Put some loc-tire on her this time.

Bolt size Support brkt to starter Seeking knowledge. What size is the bolt that attaches the bracket to the front of a gear reduction starter? Heard some rattling and lost the bolt. Bracket is still on, but need the bolt now.