Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.
Thank you every body for your help. How do you test oil pressure sender and the water temperature sender and corresponding guages. Does any body have wiring diagram for the two units.
Mike
Does any one have a picture of where the temp. sender is located and how do you check oil pressure sender or what is the Napa replacement part number for oil pressure sender?
Thank you
Mike
I have 1954 M37 that has been converted by some one and I need to get new distributor cap and rotor for it. It still has flat head six engine with 12 v distributor and non resistor 12 v coil.
I am trying to replace cap and rotor, but have no way of knowing what Napa part numbers to use.
Please...
Is your gas tank in good shape, my tank has rust inside and pick up tube had rusted apart as well.
What kind of roof you have and what shape it is in?
Mike
Looking for oil filter part number from Napa or any other oil filter brands, also looking for part number for radiator cap and fuel filter. I am going to try to start it up this weekend
Thank you in advance.
Thank you to all of you, the plate has M56 W/WM on it and the coil has 12 volts on it so it looks like it was converted to 12 volt system.
The top roof part is badly rusted up, is there any out there that can be purchased in good shape or reproduction steel roof panel.
Thank you again mIKE
Thank you Carter, there is no plate on the starter and starting is done by pushing a rod in the floor board which contacts a switch on to of the starter.
Thank you
Mike
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!