Recent content by Valor

Could you change out your front bumper?

Try WD-40 instead. No ether, starting fluid. That "diode" that looks burnt is a resistor. From looking at the colored bands on it, it just might be a 100 ohm resistor. It got hot for some reason. Good luck.

I need a cover for my 14' M923A2 cargo bed.

I'm more confused as ever now.

Was wondering where you got the fuel tank sending unit. Nice truck.

I'm not familiar with the HETT but I would start looking for a fuse somewhere that could be blown.

You only need to grease two of the zerks, one on each u-joint. The other 2 are for ease of access if needed. They are all the same according to Wes Simpson. What I did was loosen the 4 bolts on each end that bolts to the flange of the trans or transfer case one end at a time and move the...

Count me entered.

There is a block drain on the passenger side of the engine. You can take that out and use a hose to squirt water in and around the cylinders to clean out the block. Just let it drain out. Fill the radiator with hose water and let it run out and see what kind of gunk comes out. I used...

Same way here!

Thanks for the tip. I'll try that.

I've seen those before but never considered them. I wonder if you could take the zerk fitting out and use that in the hole instead of pushing the ball in. I can see why you would need a rag handy! Thanks for the reply. I'll try that. It would sure beat taking each end of the driveshaft off!

Greased one u-joint on the trans to transfer case driveshaft of my M923A2. Is there any special way to do this? How does the military do this in this driveshaft? I can't get my grease gun with small tip to line up with the fitting. Is taking each end off the only way? Gotta be an easier...

The tag shows you have 4.56 gears. That's all I can tell.

The water pump weep hole is on the underside of the water pump snout where the fan bolts. There is a small hole there that when the water pump seal goes bad, it will leak and tell you it's time to replace the pump. If it continues to leak, it will cause the pump shaft bearing to go bad then...