Recent content by Wildmax

You can check the motor first without pulling it. Just disconnect the lead and connect it to 12 volts. Make sure you have a good ground to the fan housing.

Only one speed sounds like the resistor coils are bad. They are located under the hood in the blower housing. Easily accessed and removed. Two screws hold it in the box. Most auto parts stores should have the blower motor. It is a common item that fits many applications.

Man, I really like your 09, would like to see more photos if you could. Super clean and well thought out! Like to use some of your mods on my 09. Thanks:-P:grd:

Hello, I'm adding a vacuum gauge to mine. Also a air filter minder.

Number 1. Post

I removed the army applied coating from my o9 with a HF heat gun. Worked real good. I will be applying the Raptor bed linere material to the floor and cargo area.

Looks like a nice ride my friend. I hope it is good shape for you. Mine was pretty good shape too. Still working on it, prepping for floor liner, and painting . I'm too much peferctionist though. Trying to get all the dings out. But bye and bye maybe it will get done. Best to just clean them...

The M1009 were designated as .75 ton on the option sheet by their mother GM . and so they are .75 ton. It's not nice to fool mother.:deadhorse::deadhorse::deadhorse::deadhorse:

TM 9-2320-289-34P, Figure 127 shows an exploded view with parts identified. Also in TM 9-2320-289-20 , section 8-9 are instructons for steering wheel removal.

Hi again, go to TM 9-2320-289-34, look at section 8-1 steering and you will find your answers.

Also check the TM again maybe a different one than you looked at. There is a exploded view of the entire steering column mechanism. I may be mistaken but I think the dimmer switch is located down on the outside of the column and actuated via a small rod. The window washer switch however is...

Hello, dennisS, yes you must remove the steering wheel, then a ring clip on the shaft , remove the steering lock plate. Then the screw in the ignition lock cylinder is accessable. You may do a search and find more info. Good Luck:D

Man that is a really nice 09. I hope to have mine looking that good by next spring. I wish I was closer to you. I would like to have some of that radio eqpt. Enjoy!!!!!!!!!:beer:

Decals Hello, Did you find the jacking inst. decal for M1009. I am needing one also. Thanks

Hey guys, and thanks. My 9 does have the under dash light. I just liked the military look of the one on Sharecropper's truck; since mine is also missing the dash emblem. Neat looking pelican light. Would be handy and easy to use.:beer: