- 228
- 776
- 93
- Location
- USA Indiana
I was wondering if switching voltage inputs has worked?? Like this image shows?
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
CTIS switching to different programs?
- Thread starter Xengineguy
- Start date
DeMilitarized
Well-known member
- 388
- 993
- 93
- Location
- Gainesville, GA
All I have read was theory. Im sure that is exactly how it works on the newer MTVR ctis controllers with mode settings for weights.
Skyhawk13205
Well-known member
- 159
- 270
- 63
- Location
- Alaska
CTIS pressure settings increase - no programming, transducer, or module required.
Well this is going to make a few people (including myself) feel really silly...... I've been getting pretty deep into a CTIS diag on a friends truck and had the occasion to swap modules between my truck and his, and vice-versa. And I've been going over documentation and troubleshooting info and...
www.steelsoldiers.com
GeneralDisorder did a post about the pin program settings on the CTIS controller. That is prob where you got that pic from. I have not read through it, but is makes sense, program the ranges into a controller from factory, set the pin program for each truck type, so you can swap controllers between trucks without having to reprogram.
- 689
- 1,052
- 93
- Location
- La Crosse, WI
I was reading the mtvr manual and it stated the mode button didn't change anything on mk23 variants. I think it had a function on ones with a PTO however?
Maybe that changed later?
DeMilitarized
Well-known member
- 388
- 993
- 93
- Location
- Gainesville, GA
The weight settings on the controller are the only difference between m939 and mtvr controllers button wise
Sent from my iPhone using Tapatalk