• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

Search results for query: HMMWV clutch fan

  1. The following words were not included in your search because they are too short, too long, or too common: fan
  1. Z

    NE Various manuals for sale, m37 m416, cucv, hmmwv, deuce, weapons, m715, generators, etc.

    TM 9-2320-280-10, HMMWV operators manual, 1991 edition, asking $10 TM 9-2320-280-10, HMMWV operators manual, 1985 edition, asking $10 TM 9-8015-1, engine and clutch for M38A1, portrayal press reprint, asking $22 TM 9-8014, organizational maintenance, M38A1, portrayal press reprint...
  2. FlameRed

    What have you done to your HMMWV today/lately

    It was cloudy today, so I figured I would hook up the gauges and see if I did not get all the crap out of the lines. If the new compressor were crapped out, I would see a low high side reading. Instead when I started it up, the AC was ice cold again. With 90 degrees outside, I think these...
  3. Mogman

    What have you done to your HMMWV today/lately

    Did you completely flush all the lines,evap and cond? if not you likely fried the new comp with particular matter left when the original compressor cashed in.
  4. FlameRed

    What have you done to your HMMWV today/lately

    Seems my HMMWV repairs usually ends up being one step forward, three steps back... aua It was sitting for several weeks since the beginning of Inferno Season here in Florida. I cannot take the inferno anymore in my old decrepit state and if I do go outside with the intent of working on the...
  5. Thunderbirds

    It's alive!!!

    Hello everyone. Update on the transmission pan: I was able to clean up the pan mating surface, and the old gasket. I took a chance and installed it, static leak check was good. We drove the truck for 45 miles. continuously checking in 1-2 mile intervals, then 5 mile intervals. All is/was great...
  6. Mogman

    Red Dot AC Part Number for Slantback Trucks?

    If they are both GM R4 compressors then yes you can simply change the pulley, probably not hard to find the serpentine pulley ether from a scrap HMMWV compressor or it is likely the same pulley used in some civy applications, as long as you have the 24V coil you should be good to go. Buy (or get...
  7. FlameRed

    A/C Diagnostic help

    First, let me state that I am a novice on the HMMWV, but there are certain things you can do. Start by unplugging the connector at on top of the dryer - the low pressure switch. With the AC turned on, engine running, you should see 24V on one of the leads in the connectors with a VOM. If you...
  8. Gcelevator

    Red Dot AC Part Number for Slantback Trucks?

    Steve, not to hijack this thread but, on the Vbelt compressor, can younjust replace the clutch section? I have a brand new Vbelt compressor that I am keeping with the idea of spare and clutch removal. Maybe I have been wrong all this time LOL. I bought the complete kit from Gov planet.
  9. REF

    Cooling system upgrades

    this was pretty strait forward, could not use my original fan and you will have to cut down the replacement fan. Use a Hayden Fan Clutch P/N 2839 or USMW fan clutch P/N 22613 (Cheaper option) For the Fan AC Delco P/N 15010202 or Dorman P/N 621-514 (cheaper option) same fan. I did trim leading...
  10. H

    Cooling system upgrades

    Yea I have this same fan, for me it's much better than the original cadillac valve setup, especially going uphill. I know people say these engines can run hot, but these 6.5s are not no cummins or duramax, the 6.5s are well known for a high failure rate of overheating and crack blocks. I also...
  11. WillWagner

    The next Project an ASMH

    Did a bit more TS on the wrecker. With the help of "soldier B", that would be the @BLK HMMWV guy, he actually stayed off the phone, we located the majority of the air leaks. They were the lines for the rear winch clutch lever. The fittings were falling off! The gauge on the dash says there is...
  12. OrangeElvis

    First time Humvee owner, lifetime admirer w/ a Q...

    viscous fan clutch should free wheel when it hits the water. The Black Dog clutch is fixed, so I may be screwed on fording. AI told me it's possible, but I don't like the idea of that at ALL. Anyone know of an upgrade to viscous fan clutch for an A2 engine?
  13. Retiredwarhorses

    First time Humvee owner, lifetime admirer w/ a Q...

    Im not sure how to answer this question, but let me try and understand this….so only a hmmwv with a Hydraulic fan clutch can ford water crossings? any other tactical vehicle just waits for the engineers to show up and build a bridge? All tactical vehicles are left on the Landing craft except for...
  14. TOBASH

    First time Humvee owner, lifetime admirer w/ a Q...

    Steve, good to hear from you. A friend of mine just took his rig into the ocean and ripped up his radiator. Just sayin’. I wonder if something in the design must have been changed to allow fording in the REV B and C units. What is in the revised TM?
  15. Retiredwarhorses

    First time Humvee owner, lifetime admirer w/ a Q...

    So I guess the new Geared Fan drive trucks can no longer go in the water? I mean….they use a viscous fan clutch Now on all new Hmmwv’s.
  16. Mogman

    HMMWV M1123 Clutch Fan control box disconnected

    Sometimes there is no rhyme or reason for anything that happens to a HMMWV, you are going to have to troubleshoot any issues as they pop up. It could be that one of the components in the fan clutch circuit failed or not....
  17. Thunderbirds

    HMMWV M1123 Clutch Fan control box disconnected

    Hey, shout out to all experienced mechanics here... Question. My M1123 (still on it's way from the yard, not here yet) has the fan clutch control box (also known as the time delay solenoid) disconnected. I haven't had the chance to work on it you, but to save troubleshooting time, does anyone...
  18. Mogman

    Squeaky belt

    If a serpentine belt is squealing there is something wrong, if it is squealing when the engine is revved up I would check to make sure it has enough tension, look at the pulley alignment closely, as mentioned before all new HMMWV owners should check all the alt. mounting bolts as that is a VERY...
  19. H

    M1152 fan issue

    In my opinion, ditch the whole system and go for the viscious fan clutch, best upgrade I ever did, no hydrualics, TDMs, or Cadillac valves to worry about. You may want to check your Temperature Sensor, TDM, & Cadillac valve, I kept having these go out which made the fan stay on, here's a good...
  20. M

    LEO/FD HMMWV Check List & Part Numbers

    Awesome post!
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks