Search results

http://www.steelsoldiers.com/showthread.php?130322-M931A2-Fuel-prime&p=1612652&viewfull=1#post1612652

http://www.liberatedmanuals.com/tm-5-4310-275-25p.pdf

Jimbo, be on the lookout for a reset tag , Mine has around 20 hours on the meter, reset at 2.3 and I think it was a engine related, http://www.hummerknowledgebase.com/acc/m101a.pdf I think that is the right TM for our trailers, http://www.liberatedmanuals.com/TM-9-6115-660-13-and-P.pdf and...

The blue hose comes back to a power steering hose , look like anything you might need,??

TM9-2320-280-24P has the bracket for 100 amp , part target shows it's a cast iron one, hummer guy parts shows it fits 60/100 amp, you might need to look for kits or parts from one the kit has been installed http://www.parttarget.com/5340-01-448-4245_5340014484245_12342036.html...

There is a pulley if you happen to go with a 300 Amp one,...

I like the Chef salad and Chicken & Dumplings, Jimbo http://www.hummerknowledgebase.com/acc/m101a.pdf I printed the wheel hub section and had it just in case ,

drop hitch that you can put on upside down,

2", it worked with regular trailers, be sure and lock it up for a ball hitch on a trailer , heard it will break something if it's down ,

That is the one I used on the right, with his van, my pickup is lower so I got the extra riser for mine,

The Ring is about 25 inches high, A friend pulled my M116A1 with an MEP002A South Carolina to around Ft Benning , 65 MPH with no trouble, you might want a couple of those quick links because the chains are about an inch short with a bolt on Pintle

I would try turning the engine by hand , pull handle and socket , and then see if starter has shorted ,...

Check that fuel tank has fuel and that fuel shutoff valve (Figure 3) located on the filter is positioned to ¯O (open).

Relief Valve, broken spring or leakage is something to check out,

Split-Series Field Generators (Fig. 13-17 a. Generator regulation sometimes is accomplished by means of a split-series field. A generator with this method of regulation combines third-brush, reversed series (differential), and cumulative-compound principles. TM 9-8000...

Drive shafts that are NOT in phase will vibrate with the same twice per revolution vibration as a drive shaft with incorrect operating angles. The easiest way to make sure your drive shaft is in its correct phase is to mark the tube and slip yoke every time you take it apart so you can put it...

Might help might not,... CHAPTER 6 MARKING PROCEDURES Section I. LETTERING AND SIGN PAINTING

Commercial-off-the shelf (COTS) military equipment offers the promise of technology advancement, low cost and reduced acquisition time. Unfortunately, it also offers the opportunity for a reliability and logistics disaster because commercial parts, standards, and practices may not meet military...

https://www.youtube.com/watch?v=H9wCTdfDgQA No ordinary rivet indeed,...

Thanks Ahab and MG, so I wonder if a regular rivet gun would mess up the threads ,