Search results

I went out and took some pics of the fitting. This is what I did. I think I did a post of this many years ago.

I think I took the fitting off and drilled and taped a 1/4"pipe hole. I have tried to find photos of the work and I can not find it. Good luck with it.

When I first got my truck the HD motor on the crane was leaking. I had it rebuilt and after I started using it started leaking again. The shop said I needed a case drain. The motor I have is made by Parker. I put a case drain on it and ran the line over to the HD tank, I also put a one way...

Very Nice!!

Here is what I have and used on my rebuild. Oil Pan bolts 40 lb-ft Intake 30 lb-ft exhaust bolts 25 lb-ft Rocker box covers 15 lb-ft Rocker box bolts 65 lb-ft Head blots 25 then 100 then 200 then 305 lb-ft Rod bolts 75 then 150 loosen then 30 then 75 then 150 lb-ft Crankshaft Main 140...

I just rebuilt a NHC250 and have all the torques valves, if you let me know what you need I can send them to you. A repair manual is very hard to find, may try Ebay.

Here is a link to a good write up on setting the valves and injectors. I think you would use the OBC method. Go down to post #8 https://www.steelsoldiers.com/threads/nhc250-valve-injector-overhead-adjusting.73256/

You can pull the injectors and put oil down the cylinders. If you remove the adjusting screw all the way and move the push rod over you can remove the injector. It is the rocker in the center. You will have to set the injector when you put them back in.

Make sure it has the return spring on it.

Welcome back!!

I would take it out and clean it and replace the o-rings and it will be good as new. If it is pointed to the back of the truck it is the left tank if it is pointed to the drivers seat it is the right tank. But someone may of put it on wrong.

Have you checked your hoses to see if they are the problem?

I think any Lithium base grease works.

Thanks, it is a nice Tractor , I got it last year it replaced my John Deere I had for 20 years, I just wanted a tractor with a cab, getting older . LOL I replaced it with a take out engine I got from fuzzytoaster in TX.

I'm replacing an Engine in my friends M923, he let the coolant go bad and it eat the Piston Liners and let coolant in the oil. Not good. I got a take out engine from fussytoaster. I will do an Autopsy on the bad engine later on, but for now just putting in the new one. The one photo of the...

There is some places that can make tubing for you. I had a power steering line made and it had like 5 90's in it. Just look a round in your town and you may find one close to you.

Great find, time to start making and selling them.

I put my cutoff switch at the end of the battery box on the drivers end. It is a Cole Hersec Besure to put it on the Neg. side. The black box in my battery bix is for the Econ lights on the truck, All the battery cables are not hooked up to switch in this photo. COLE HERSEE 2484-03-BX -...

Are you sure you are reading the #540 right.

You can always down load the TM's from this site. I did find wire #578, it goes to the Air pressure switches on the air tanks, they are under the right side of the cab by the tool box. I could not find wire 540.