Search results

This one: N30252B on TM ...-24P, page 383, item no. 18. Thanks a lot! Christian

For the entire check valve yes, but not for the repair kit... Christian

Hello! Do you have a part number for the repair kit? Thanks! Christian

Yes, they were tied together. I didn't notice about it, I saw it only after I pull them out... ;-)

Here some pictures of a revovery. I didn't be aware that I pull out the truck and the jeep together.

Hello. I have some videos recovering a truck plus 4x4 jeep stucked in mood. I have it only on smartphone, I cand send it to you or post it, as you prefer...

Do you have a link? I cannot find it on web...

But do they had 225 or 290hp? I think there is a lot of diffrence if you keep the original hp and the modified... Christian

Hello! I am thinking about putting on a M1078 with the 3116 engine and 225hp the high speed gears and 3.07 ratio. But I am not sure about the loss of the 20% torque, if it's noticeable and have on steep / sandy terrain a negative impact on handling/performance. Does anyone have experience in...

The CAT code of the 2 o-rings are 4J5477... Bought together with the tube, but after reading this thread I decide to switch to PTFE flexible hose. in my opinion (but I am not a expert) the problem in this tube is the diffrent vibration produced from engine and air compressor. Even more if some...

Yesterday I change the steel pipe with a flexible one. When I loose the upper fitting I saw that the steel pipe was under tension, IMO because if you tight the fitting on the side of the governon the pipe tent to rotate versus the engine. Maybe the mix of tension and vibration is the cause of...

https://hifi-filter.com/en/ have a filter cost the half of the original one.

Hello all. I have a CTIS ECU based on Arduino. The Arduino sketch is somewhere on the forum, I share it... What I did not share (because it's quite easy to manage) is the board with 3 relays and the 2 inputs for wet tank switch and pressure transducer. Christian

Hello. Looking at the oil line I have an idea. Why not add a small bracket on the right side where the breather is? There is a big screw that can hold a bracket that holds the oil line, preventing vibration... Christian

OK, maybe I disunderstand the first point of the very valueable PDF of the 3116 failure points, the Compressor gear nut loose. I though it was the nut that holds the gear in place... Not the bolts that old the compressor in place to front housing and bracket... Christian

Hello forum. What is the best way to check the compressor gear nut? It's a common issue and I wonder if it's usefull to check it once per year. But do I need to remove the hole compressor to check the nut, or it's enough the remove the front housing cover? Thanks a lot and best regards from...

- 3116 Engine year ...1997 - Engine serial number ...7AG04596 - approx. position of the union on the block ...mine looks like the pic you attached, not straight...but it is bone dry, for now... - has yours broke ...NO - is yours leaky presently...NO - I will replase the oil line with a new...

Hello all. Today I was sniffing around under the truck for some mantainance and notice that of 4 screws that hold the starter and attach it to the flybar, 1 was lost and another one was on the way of loosing... So next time when you are under your truck throw an eye on it... Christian

Hello! I immagine you use a flexible tube instead of a rigid one... Can you please tell me what type of tube you use? Pressure is not really a problem I think, but temperature? Thanks a lot!