Search results

Dangerous findings, back pad no ceramic braking metal to metal, front pad ceramic was not attached and cracked, that little clip fall out, do I need another (two)? where does it go? new stuff all chiness junk

I just removed the caliper, but the rotor is not coming out as easy as all the youtube friking videos showed. 8( Do I need to take the whole hub out first? I’ll post some pic in a minute thanks

Try to check how much current is that beeper sucking, you do not want to overload the glow plug card. If is just a few hundread miliamp should be ok,

I asked at NAPA but they sell the whole injector kit for 80 bucks, but only one injector is leaking, Can I put coper or crush washer that fits on the injector or any soft sealer?

http://www.blazerchalet.com Hi, has anybody been able to get hands on one of these? Is there any out there with an after make truck camper that fit the cucv?

Actually I first bought a 10Amp switch to installed aside the voltmeter with a trick label saying “fog lights”, like I have in my jepp. But then I was thinking on the stereo and an alarm system will protect both. I have the common cucv key.

Pink wire at IP, can I use this with a relay 12V 40Amps as starter cut off? I was thinking to install an alarm with a relay to open this pink cable on the Injection Pump as another option to secure the truck while park in public places. Anybody did it here? Any ideas? I prefer no to use...

it's all good!! thanks RTV will be

part number 6

(the housing) the part #6 page 257, fig 109, at the TM 9-2320-289-34P, thanks

Anybody has a napa or autozone part number for this gasket? thanks

you can go up to 2 micron filtering, I think the original is 6.

I open the water drain but nothing comes out, water or diesel, is this normal?

ok :-D, cucv running after charging batteries, diesel kleen not a good idea. How is going to affect not having the fuel pressure switch any more?

I read someone was doing 100% diesel kleen on fuel filter changes

the "in" is to the 3/8 hose (tubing), the "out" is to the 1/4 hose (IP)

Mod: http://www.steelsoldiers.com/cucv/36435-my-cucv-spin-fuel-filter-mod.html I just put Pawnshop spin on modification, I filled the filter half with diesel kleen, crank it with the PI pink cable disconnected to fill the other half with diesel, put it back but It did not start, then I open...

For the two alternators I found holes in the bracket where I can put a screwdriver as a lever and adjust the belt where I want it, but for PS belt is there any trick?

Thanks I went to AutoZone and they change it for me using an impact wrench, they did it so quick that I did not have time to complain that they put it back using the same impact wrench; any way seems they do it very often in that way, I hope they did not over torque. They told me the old...

I try to remove the pulley retaining nut, using a vise and a 15mm socket, it didn't move and I didn't want to force it, there was like and allen screw on the shaft but I didn'tt have a socket for that size. do I need to take this one or just the nut?