Search results

im with you but this is something i have limited knowledge on at this point thanks ill send them a tell

so update repaired the circuit and it worked for 30 seconds after flashing the field then in burned R20 and went back to the old behavior right now i have a tech that works on industrial electronics looking at it but would like to have a back up plan i keep hear that people have adapted modern...

yes indeed found it this is what i found for further reference CR12 TO CR23 orginal part number is 1n4246 updated part number is 1n4004 CR7 & CR8 original part number 1n4247 updated part number is 1n4005 R20 is a 39 ohm .25 watt R19 & R20 are 10 ohm .25 watt I ordered everything from...

ok so opened it up today and was expecting to see a burnt transformer instead burnt resisters on the vr now i need to see if i can find a schematic of the vr board and the values of these think ill replace all these diodes while I'm at it they look ruff

ok ill have to get it out tomorrow and take a look at it.

its the box with 2 plugs on the starter side of the engine?

hello guys! so finally got a new engine for this unit and after rebuilding the injection pump on a CRATE motor lol finally got it to start and run the unit itself has sat for roughly 4 or 5 years after the previous owner threw a rod out the side of the block. on start up and ran the unit up to...

ok good idea thanks!!

do you know of any good auction sites for them?

i have a mep-005a with the whites D298fr threw a rod on cylinder 6 looking for a short block or any one that may have a complete crank and piston i know there are several complete engines on ebay but wheres the fun in a engine swap where do you guys dig up engine parts for these? or i was...

ok awesome thanks once i was able to find the manuals section your walk threw makes more sense!!

ok thanks this seems like what i need where can i find the UOC for these 2 models can i find a collection on this site like there is for the onans on smokstack? ps to clarify i needed parts on the motor for my mep-002a but plan to mount a mdjf "marine water cooled onan" basicly a water cooled...

you are correct it is the coil that is controlled by the voltage regulator to excite the main field the small ring of coils mounted on the end of the stater housing

that's a typo was supposed to be magniciter a friend has a 60 hz stater if my rotor and magniciter will work with it also what is the usable on code ive tried to find parts manuals for the 400hz model and can not to compare part numbers.

hello i bought a mep-112a for parts to put on a mep-002a i want to take the left over control system and mount my onan mdjf on the skid and use the original controls for that unit. question what parts are 400hz specific in the control system? and can any of them be adjusted to work with a 60 hz...