Search results

Yes I have a copy of that. I think from reading the letter that the SSI eess box will work on our Humvee with the burned out yellow Nartron eess box. I will not have to change the temp sensor between the two. However, I don't know the nsn for the silver label KDS PCB I have pictured or if the...

This one in our third hmmwv works just fine. Engine fires up in less than a second even when its really cold.

Doesnt answer my question. Im not talking about the s3. Im replacing yellow label nartron and silver kds with 6110-01-491-2152; ssi box. Will the two sensors in crossover left from nartron and kds work with ssi

These two are bured out. Have SSI boxes on the way to replace them. Will the temp sensors/controllers still left in the two hmmwv work with the new SSI box?

Yeah 381-190 i have that info as well. Just want to verify tho. We just split a coolant tank using wrong thermostat for 6.2 instead if 6.5

Ive been pulling my hair out with trying to cross over the ac delco number with one at a local autoparts store.

Ok what are the part numbers for thermostats i can buy at autozone, advance, napa, etc for thermostats for 6.5 engine?

Drmo for law enforcement agencies.

I gotcha. Wonder what works best? Silicone the heck out of it?

Can someone post a picture of and describe where this notorious cannon plug that corrodes is located?

Good. I thought that blue female bullet connector might work. Used to sell a ton of them at advance auto

No this is not on the cucv. Its on a drmo hmmwv we requisitioned. Im getting the new plugs but wonder where im going to find the female connectors

Thanks!!!

Isn't there a resistor that steps down the voltage?

Ok so our maintenance shop installed 12v spade type glow plugs in our humvees instead of the round connector 24v glow plugs. They cut off the round connectors too. Will this cause problems? M1025 and 26 models.

Is there a guide on how to install these anywhere? As far as i can tell you unhook the batteries, swap out the box under the dash with the new one, swap out temp sending units with the new one, and then reconnect batteries. We have yellow label nartron eess boxes under the dash right now.

i noticed our starter will crank fast then retract away from flywheel within seconds of spinning. the starter gear keeps spinning or whines away from the flywheel if i hold the start lever

Ive read a lot of confusing posts about this. I plan on running a strobe lightbar, siren, and radio off the rear 12 battery and read about running a wire from the front of the regulator marked 15v to the same rear battery for individual charging. Problem is, it doesnt put out 15v when checked...