Search results

Would anyone have the driver side support tube that is typically attached inside a rear sponson?

Thanks. How about primer?

This question must come up every 5 minutes...hopefully this isn't too annoying and someone will give me some ideas. I'm planning to completely tear things down and start sand blasting and repainting all the frame, suspension parts, etc of my hummer this winter. I'm thinking of going for a flat...

Yeah, the turn and walk away part I like.

Are the tumblers really slow in comparison to the blaster? Or not too bad?

I have a lot of small parts and was wondering if anyone has used one of those vibrating containers full of rock? Or steel beed? I'm not sure what's in them. But they're basically a container that vibrates and its full of a media of choice with your part in it. Takes a while but it should...

So there's probably no problem selling to Canadians if I let them handle the import/shipping then?

What paperwork would that be? For a private sale?

What parts are prohibited from being sold/exported to canadians? From what I know GL has certain restrictions on their sales. Would something like a roll bar be ok to sell to someone up north? All my parts I'm interested in selling have been through private sales.

I was thinking about it but it hasn't been driven much the last few years. Not sure I trust it to get me home.

Looking to get an H1 moved. It's running just fine.

Anyone have a roof support for a turret they wanna sell?

Thanks for the info. Was that the only style that was made?

Are any parts interchangeable between the 2 turret versions? Especially in the turret support, like the B pillar supports?

Do the armored roofs go overtop the regular roof as armored panels or would it replace the roof altogether?

Any for sale out there?

Anyone know where I can get a set?

Haven't seen any hard tops for the truck/2 seat configuration. Are many around?

Can someone tell me what these 2 lines are that run along the side of the hatch?

Are the bearings sealed on the m1114 style turrets? What's recommended for maintenance to keep them spinning freely, along with the other moving parts like lock and hand crank.