Search results

Thank you for your reply. It sounds like you've kept using your MIL wheels. How are the bolts holding up (that hold the two pieces together?). Do they need replaced often, I am assuming that you always need to replace the wheel gasket and probably have a couple of spares. Do you know of...

Kind of like not planning on being a parent, I didn't plan on having a hmmwv 'right now' but I do. And with it, comes ups and downs... anyway, being up in AK is probably the worst place to have a hmmwv to work on/rebuild/etc. I saw that the tires have dates stamped on them (i.e. week and year...

Good copy, thank you very much.

I should have been more clear, I was referring to the connector. Appears to be two wires to one connector and it didn't come apart after I pulled on it. With my luck it might be the only twist and pull connector on the entire truck that I yank apart then have to buy an entire new wiring harness...

I apologize, I should have been more clear. I was referring to the connector. it doesn't appear to be a regular barrel type connector. It has two wires mated to one connector. I pulled on it but it did not come apart so I was afraid of breaking it.

Hi all, I need to test my transmission light to see if its burned out/ruined/etc but it is stuck on pretty good. Is there a special way to remove it? Twist and pull, just pull, etc. I don't want to just yank on it and end up breaking it. Been there, done that before. Thanks, David

Thank you very much, I appreciate it.

that's exactly what mine sounds like, except for the bumping noise when you push people out of the way :-) Thanks Camo, you're the best!

Someone deleted my other post... some people... I have the same noise and was wondering what it is. I have bled the ps a few times, and I still have it. Noise starts as he drives and as pretty evident at .40

You're completely right, error on my part, I looked into it some more and after doing the meter test and following instructions to test the truck, the truck actually reads 0.00 with the kill switch on and off.

I wasn't expecting any draw since these things are so 'mechanical' but I am totally new and learn new stuff about them as I go along. Thank you!

Never thought about that connection, that make sense - thank you very much.

Just heard about parasitic draws on vehicles and one video mentioned at some rate its okay or whatnot. As shown in the pic, I have a kill switch in between my batteries. I tested it today by removing the neg cable from the rear battery. With the kill switch open (no power to truck), it read...

Thank you very much.

Thank you very much.

I have been working on my A2 for since I got it in Sep. I still have some issues that I need some guidance / feedback on. From the tranny to brake lines to my question below... in the skinny compartment next to the battery compartment, under the passenger front seat, I have this item which is...

My trans light has never worked, I will have to pull it to see if its burned out or if there's another issue. thank you

I will have to find info on that. - thanks

Question for anyone... I was running my m1097a2 without a brake switch (and therefore the tranny plug that is connected via the brake switch)... it would shift just fine. I plug in the tranny plug (whatever you call it) and it goes into limp mode. Unplug the from the brake switch and it...

Thank you very much!