Search results

I have sold all of the last batch of reinforcement plates I made this Spring. If there is enough call for more, I could run some more perhaps this Winter. I have been making them a dozen at a time and basically selling them at my cost.

Check the classified section.

It will help everyone to see a military install. I have seen several but I have been without a camera on each occasion.

I hope to begin shipping next week. That will depend on the rain stopping. I do not have covered transport from the shop and if it keeps raining that will delay bringing them to the shipper.

I kind of settled on a price of $150 including shipping. It was too much of a hassle and always the shipping brought the price into the $145 to $155 range for the most part. So, I put a little in on one and kept a little out on the other and save a bunch of time. No one has complained about...

I can have another dozen or so made fairly quickly if there is a demand for them. Currently, I have only one for my own use.

The originals had some surface rust as if they were stored outside for a long time. I got mine early on from you. It sat a while but I was up at RAPCO one morning when Mark indicated he wanted one also. It seems there is no supply available other than the batch you found. So, I leaned on a...

Mine is painted and ready for installation. I painted it VN green.

Here are the pics

I started from an original I had in the garage. These are not painted, so you can put on the color of your choice. I do not believe you can find them at a lower price. If the first dozen sell out, I will make more.

See TM 9-2320-361-24P, WP 237 for the drawing. These are extremely close to being duplicates of the original. The u-bolt holes might need a bit of a touch up with a grinder for authenticity freaks. $100 each, plus shipping from 76201 I will post pics tomorrow.