Search results

even if it was a bad bulb, would that prevent it from charging?

Ok to start off only Gen2 light comes on when the key is in run position, and the volt gauge is in between the red and yellow on the left (low volts) side of the gauge. I crank her over... She starts up, and Gen2 light stays on for a little bit longer, then proceeds to go out. The problem. Gen1...

hmmm really?. What about if i dont have the fan shroud? would the cooling be sufficient enough? It got pretty eattin up when the fan hit it n threw pieces through my radiator.

Yea, my oil pressure guage has replaced it. I'll pull the vacuum lines lines n replace them when i get a chance. Do you know how that black sensor on the left of the IP is suppose to set? i looked in the TM and noticed it said "dont fully tighten". I am guessing that this is because it is...

Ah gotcha! did some more lookin around today and got a fresh set of 6TL batts. mucho thanks on the info mangus. Yea, ralbelt those gauges down there give me oil pressure and water temp. Also finally got the motor to roar! yay! My gen1 is def dead. threw a multimeter on it while the motor was...

To start, im new here and have searched around here for the answers before comin here even in the TM. Anywho i uploaded a video to youtube explaining a couple of things i have concerns with. This all started when my brilliant friend put the trucks batteries in parallel vs series. I walked back...

Well I've seen this sucker layin around for a long time and finally decided to pick it up and resurrect the beast :). The motor runs, but im gonna do some cleaning up before i actually use the vehicle. I hope to find some other enthusists out here in New Mexico too :). Take care guys! Only have...