Search results

Thank you. Great idea. I’ll go out and find one of those connectors. Wonder if Amazon has some.

Sounds like a plan. Will see how it goes. Thanks!

I need to look up the polarity. I’m sure it’s on here somewhere. That would def be a catastrophe if I crossed them. looks like this is the idea based off what I am seeing: In a NATO plug, the center hole is positive while the surrounding part is negative.

Sorry to dig this back up. But I’m trying to get a charger/slave plug solution setup. I ordered the NOCO Genius Pro 50 and I just ordered the Graywacke cable “GEISLV-LC-10Mini Military Slave Cable” assuming this will work. What do you folks do to connect the slave plug to the NOCO?

Thank you for the info. This is great. I did already order all the parts. But I could return some. Unsure what I’ll do. I’m tied up with work and I think it will be a week or so till I can start anything. I picked up the Pro 50 + thinking it would be nice for the garage in general. I have been...

I just ordered the yellow tops and the optima battery box (holder) to mount them in (inside the Humvee battery box). I also ordered a set of the red terminal protectors. And I picked up a NOCO Genius Pro 50 to be sure I am able to charge... going to get that slave plug to use as a charging port...

Thanks! I’ll look into this as well. It’s interesting.

Hello folks. I’m going to replace the batteries in my m1123. The ones in it are mismatched and old. I want to do a yellow top install. And I want to try and use a custom battery box hold down. I thought I’d share for feedback and to let others know of the option. Based off my research the D34...

where did you get the pos and bed boots, and is that the factory metal battery hold down? Your work looks clean. I’m replacing some indicator lights and about to replace the windshield retaining bracket. After, I’d like to clean up my battery area too. Mine has some bent areas and it’s just...

From MME. it’s the 300$ switch. I think from my reading. It’s the not the factory switch “Nartron” which is usually in the 700/800$ plus area. I’m going to request a replacement. I hope the allow it. This switch is so tight, it bent the canceling pins on the steering wheel hub (custom wheel). If...

Hey folks. I just installed a new turn signal switch and it’s really stiff. It’s hard to cancel and requires manual reset. Is there any way to free it up?

I’ll replace the filter and recheck. It is when cold. I haven’t tested when hot. Might get it out tomorrow and get it up to temp and retest. I saw where someone did some Diesel Kleen too, and it fixed his issue.

Hey folks. Second post today :) I noticed today after I replaced my belt. When I rev up the motor (push gas pedal a few times to increase the rpm) I noticed that if I just let off from a rev, the motor dies. It will start right back up. But I don’t know if that’s normal while in file (🤔) or if I...

He guys. I have a 2010 M1123. I was replacing my belt today (finally no more chirps!) and while doing an inspection of all the pulleys I noticed the power steering pump pulley has about a mm of in and out play. It spins nice, just a tiny bit of play. Is that normal? Can someone put hands on one...

Hey thanks buddy! I will admit I have been lost in links and documents for over an hour... but it's all interesting. ;)

Thank you so much! Ill dive in. I do know it has had a full service before they shipped. So, I will need to figure out the interval from there.

Hi folks, this is my first time posting. I purchased a custom M1123 last week. Waiting on delivery date. Its a 2010 with the 4 speed transmission. Id like to do some readeing and see what I learn. Could you point me to them? I know I will need a belt, or idler/tension pulley replacement... It...