Search results

So if we are not using the trucks in extreme conditions and high heat, Why is it necessary for an oil cooler? These engines run on the cool side and civy trucks of the day with 6.2 and 6.5 like panel trucks did not have these massive coolers plus no ac condenser in the hmmwv stack like a civy...

64 in stock as of this posting Try https://real4wd.com/product/plate-identification-m-998/

Please post pics mounted This could save big $ over military 60amp units and way more tolerant to not blowing regulator and more robust and higher amp. Nice job!

Correct, we have old school radiators no aluminum

Search here on ss in the hmmwv will answer your question. Btw, he is a member and vendor here.

No one but the military kept using the old school nhc250 so the years don't align. M35a2 gave you the correct part numbers. Many threads on it here in the 5 ton section. The spin on come in many flavors of extended capacity, drain intervals etc...

Adding a block heater to a nhc 250 is super easy. You can always capture and reuse the coolant with the drain cock if good.

Btw, the rak15 unit uses the same 3 pin connector on the flasher unit if you need to get one from someone maybe parting out a mv as they are the same for many years and trucks.

The lock ring is mechanical. Good job on mounting those up!

Thanks for doing this!:tank:

Those are LT so they will handle higher weight and pressure. 30-35 normal loads ok and you have wiggle room to pump up when carrying a heavier load. Your limiting factor in my opinion is the tube. Is it a radial tube? Did you put flaps in to protect the tube?

Yes, you can replace the rubber seals. Not sure if those are fmtv or combat wheels. Probably need to check dimensions.

They are out there on ebay and Oshkosh https://www.oshkoshequipment.com/products/detail/281/1783/Combat%2DWheel%2DRim%2DValve%2DStem I have fmtv rims on the front of my 5 ton and combat wheels on the back. I used large bore commercial stems on the back as I do not plan on rotating. My spare is...

I am guessing a field modification for an amber warning beacon light is my guess for the switch. Welcome to Steel Soldiers. As a kid I lived in Rome 1971-1972. Wish I had been older.

You need to post the pics of the base data plates or pics might help. Most hmmwv have as3900 mounts but you can have older or newer harris models?

I use spray foaming kaboom mold and mildew cleaner on vinyl covers here in the sub tropics :sneaky:

Ibis Tek IR/halogen light bars were installed in some MP trucks on the front windshield that also had flashing blues. Some slant backs also had a rear facing 24 inch light bar in the back. I have also seen some gun trucks with light bars on the turrets probably field mods. These were probably...

If you have wet cell batteries, pop the caps and check fluid levels. Batteries could be boiling over needing acid/distilled water mix. There is a simple ball float hydrometer tool to check acid water mix.

Yes. Radio mount on a fender mounting bracket. Also newer style antenna mount tower. Sometimes there is a reinforcement plate underneath the fender for antenna tower. I would be interested in the tower and plate if you have no use.

Can you post pics? Ibis tek light bars were used on some models.