Search results

When it stops hissing what is the pressure? An audible air leak is an out of service condition regardless of weather the truck passes COLA.

Why do you want a sliding fifth wheel?

Why do you want to use the articulated fifth wheel?

The Allison spec is for the transmission to shift at 300 rpm below governed rpm for all gears but the highest. This shift is supposed to be 500 below governed rpm. You can cause the transmission to short shift by not applying full throttle. You can also hold the gear by manually shifting...

And to top it off I just picked up another shelter. For the door handles what is the shaft size? I have found them in both 5/8" square and 5/16" square. In the locked position is the shaft orientated like a square or diamond? I have a source for both. I have not done any build threads because...

Nice I need to work on mine after I Finnish the S-280

Simple solution stay off the jeep trails.

One thing that has not been brought up is that the 110 machines need a 20 amp, or larger, circuit to operate at there potential. Most 110 circuits are 15 amp. The 220 machines will work on an electric dryer circuit. Yes you can make extension cords for the welders. They are just heavy and not...

The red, lincoln, or blue, miller, debate will go on forever. Both companies make good machines. My mechanic is a diehard blue, miller,man but his mig machine is red, a lincoln. Duty cycle is important once you are experienced. Before you have the experience a machine with a higher duty cycle...

Lincoln or Miller is like the Ford verses Chevy argument. I grew up with Lincoln machines and now own two of them. Both are 220 volt and set up for flux core. My older machine was Lincoln's first small 220 machine, it is over 20 years old. It is called a SP130T, they later called it a SP170T...

Please do post the service alerts.

He needs to go through a DMV service. They do give you a hard time going from commercial to historic. They think you are just trying to avoid the fees. Where is your friend located?

They are load if you run them as they are but you have to remember that they were designed to be located inside of an insulated enclosure. I added a sound insulated enclosure to mine and it is a lot quitter but it is not a honda.

I did not see where they specified the tire position. My tire guy had a difficult time locating cross tread tire that was rated for all position. He found a firestone tire that worked better that the tires the factory put on the truck on the run to tower park last month.

Civilian trucks vent the air from multiple locations under the vehicle. This vehicle has the vent line plumbed to the air intake. This causes a different sound.

CA is just following the federal rules on drivers licenses. That is except for requiring a class b for a 3 axle over 6,000 lbs. Historic vehicles and motor homes are carb exempt. All being said CA is a lot easier to deal with than a lot of states. You just have to follow the law.

I made a simple one to start and test the generator. Once I get the new one completed I would let it go.

The AB 15 base and three section antenna composed of the MS 116, 117 and 118 is very close to the length of the long whip used on the CB radios We have used these with CB radios in the past.

Are there any drawings or plans for them?

How are you going to balance the loads?