Search results

thanks man. will order right now.

that's what happens, i have been looking for the gasket but i dont see one. should not leak without gasket? same on the pump, that's why i was asking.

What kind of gasket goes here? I can't make fit the one in the picture. Am i missin something here?

Does anybody know of a cross reference number for a lift pump from napa or any other retailer. I guess i punctured my pump while mounting the engine.

At $8.00 yes, at $30.00 a little pricy.

It usually is like that but, with those prices and how many thing we have to do/upgrade on these trucks, Is better to save a couple of bucks whenever possible.

Yeah, they have lost total respect for our money jajaja. I might replace the ones i used in the future, at least the rear ones as they look funny on the truck not matching the original mounts.

So i will assume the rectangles are for the hood lift.

Good to know. Seems good material. 👍

Look at my post. My truck also sat for years after rebuild. Replaced IP and started and suddenly a exhaust valve got stuck open and destroyed a cylinder turning the block garbage. If i were you i would rebuild or buy another running motor knowing now how it is inside. Good luck whichever way you go.

I bought 12 hockey pucks. Works perfect. Might change it in the future as does not match the size of the original body mount. I also thought about making it out of starboard. As of now it works.

2" lift on the body. I also have to drop the fuel tank. Yes, i asked him how much he wanted but never got an answer back. I would like to install a new harness as it would give me piece of mind and honestly the NA harmess looks new and it would be a crime to chop it up.

Engine is in the engine bay already, transmission bell attached to engine and torque conerter attached however i have to torque it down. I do have a question for the ones who have done this conversion or open to any ideas, how would you route the AC lines. If you look in the 2nd picture, this is...

I spoke to AM general today and the part Number is 12469287 and they show it online but takes sometime to ship as they are short on wires. Go figure.

I was checking into this but i believe that part number is for a non turbo (not sure) i will have to check the other part nunber in stock which i believe is for the turbo. I believe the below link is for the turbo but i have to confirm this...

I know he is not, honestly it never occurred to me to search that way since i am new at surfing the TM's. Will start searching tomorrow and see if i am missing anything wire wise.

Thanks. That narrows down a lot. If i recall correctly in my earlier posts you are doing a swap similar to this, or i am confused with someone else?

Action, i have gone up and down the TM's and have not found one for the turbo engine. I found the one for parts but does not show the wire harness. In this case i was curious to find out if it was a stand alone 3 wire harness as this one does not show any other damages. I have also followed the...

There are a couple of wires that they don't seem to be ripped from the harness and i found them onbthe box given to me with the engine. The wires are 349 B and 359 F, also 33 A. Can anyone confirmnif these wires are in the turbo wiring harness or they come separate. The reason why i am asking...

New engine started and ready to go in.