Search results

Re: 2013 Haspin, June 13th-16th How much did they charge to test? I have a set from tm America and would like to test them

Just start a new thread for the event and link this page to it. Then the masses will see it and get more attention, then you also get to vote.

Same here, I cary a manual grease gun for on the road and a pneumatic gun for when i am greasing off shop air. It makes life so much easier. I also put 3' flex lines on my guns with swivel nozzles to make it easier.

If your are in a rush to test the unit Sunbelt rentals rents generator load cells to test generators. I use them all the time at work and may have slipped mine in an time or two :roll:. They work good and dont have to have it sitting around all the time. Also nopics

check over your wiring harness for damage. then check the control box for damage then look over your sensors for oil pressure, temp and fuel level

Did it run then just stop running? Can you crank the engine?

Re: 2013 Haspin, June 13th-16th I will probably pump alot of grease into the boots just to be safe. They tore last year and are starting to ooze grease.

When we receive equipment it either matches refurbish quality ebay or scrap. If it is scrap the drives are degaussed and sent for shredding. We process all the cords on house, we ship 36000 pounds out and get about $18000 for it. We are a 501c3 nonprofit in Cincinnati. I am on the board of...

Welcome to the site. Come on out to Haspin in June for the rally

Computers hate and fear me. So far this year I have sent 240,000lbs to the shredder, but have refurbished 800 units as well.

Re: 2013 Haspin, June 13th-16th I need to drain my front differential and refill, drain the transmission and transfer case and refill, do new rubber boots up front as well and install my LED headlights. Then pump grease in to every thing.

Re: 2013 Haspin, June 13th-16th I am replacing my alternator this week. Adding a12 volt setup I got last October and installing a pyrometer so I can adjust the fuel screw. Then replacing ask of my front wheel studs.

Re: Jefferson City MO Loadout & Guidance I drive past there going out to the family farm. You will have to come on out to the Haspin rally with that. :beer:

Re: 2013 Haspin, June 13th-16th Is it June yet?????

Rickenbacker air force base just south of Columbus has a5 ton with a plow and salt/sand spreader in the back.

Re: Jefferson City MO Loadout & Guidance What side of of Cincy are you bringing that gem to? Good looking truck

Re: 2013 Haspin, June 13th-16th Looks like we might be getting the John deer test drive again. :D I am waiting on them to fully commit but they are interested.

Re: 2013 Haspin, June 13th-16th That is what happened to my truck. Last winter I was bored and a bunch of parts laying around and now my truck is lit up like a christmas tree. :D

Re: 2013 Haspin, June 13th-16th Just put strobes and lights on it. :D

Re: 2013 Haspin, June 13th-16th I think there is a 20 foot exclusion zone around gimpys truck at all times. :beer: