Search results

I need to visit DFW for family anyway, I'll show if invited.

I've not heard of this email address before. I have to call in constantly to ask for an update on my multiple tax refunds from GP and no one knows anything nor do they call back. Average refunds time is about 8 weeks it seems which is ridiculousness since the money wasn't supposed to be...

I've noticed the retaining pins for the extending lift points on most of my M1082 trailers have gone AWOL, being they are large pieces of steel I thought they'd best be secured before travel. I found a commercial replacement pin form Tractor Supply that fit perfectly and is a little easier to...

Be sure which interlock is it first. Solenoids A & C are identical units and I have new replacements for $120 shipped if needed.

I've seen a few items get recycled 3+ times over the course of a few months. I can understand if the item is immediately relisted if the buyer backs out and pays the fee but I can also see why GP might hold onto the item and relist a short while later. I know from the GL days if a truck got...

Dropped my front drive line on the M923A2 due to the vibrations at 40+. Found the mystery leak that made it loose prime..RRAD didn't tighten the copper fittings inside the frame before it connect to the rubber line (hope that did it).

Could be a short or bad anything in that circuit. Take a temp gun and go to town, don't trust the temp gauge. I had a JRTC truck with a deep fording kit on it and it would "over heat" when it warmed up.

It should be the same setup that an M35A2 would have. There's plenty of threads on the site for builds. :doghead:

I couldn't source them except through the distributor for Dewey. If you or anyone needs them they can get through me at cost as they have a minimum order amount ($$$) and I had no choice but to buy more than I needed. :doh:

Working with a local VFD to change their 1079 into something more capable of service. Got a box in trade for the cargo bed..may mount the box back to the trailer chassis or who knows.

If these are the ones I was looking at recently the NSN said Buffalo MRAP as the designation.

Petcock is on fleabay. What do you mean by through exactly? The rubber bushing on the tank to connect the fuel return line? If so I have some. Also got mine running today and the only thing better than the quick start is her purring nicely. I will load test it tomorrow and break it in some. 3.1...

The injectors could be used in a pinch but mixing the two types would be bad as they actually inject a slightly different amount of fuel into the cylinder and a different "pop off" psi. Replacing the entire set of them shouldn't be a problem as I've pulled both types from the 855 blocks on the...

I'd go with G177s on a deuce but back on topic I put MVTs on my M915, M923A2, and a few dueces and loved them all the way. Avoid the XMLs unless you can verify their date as they tend to be an older tire thus more prone to cracking.

Would you take some of the 90 degree elbows and rubber bushings for the fuel tank? I have read the TM but I'm skeptical about them holding up.

I picked up one with 3.1 hours from the factory. Was missing all the fuel lines and gaskests to fuel tank (which never had fuel in it). Can't wait to get it together and running.

I've had my M1082 for a few months now and use it weekly. It's a perfect fit for my M939 series trucks and seems to be a well thought out trailer.. ladder included!

Avatars don't show for me and haven't for a long while. Who knows.. :-?

It can go as deep as you want it to, getting it out is a whole different deal. :roll:

You'll be in good company, the Houston area is crawling with helping members.