Search results

here is pic from 2013 I need to get a better picture of as the truck looks much better now. Sent from my Z932L using Tapatalk

Yes I have run it to get the engine good and hot. In fact I have put about 150 mules on it. It doesn't seem to matter fuel wise fresh, old or somewhere in the middle it still dies it. Your right about it being tight with line. Its so tight I need to remove but have not been able get loose...

I have not adjusted the valves yet as I can't get the valve cover off due a line near the back end of the cover that I can't get loose to remove to allow enough clearance for the cover to come off. Although I think the value are correct as the engine had been rebuilt and never ran much it sat...

OK I will try that I have it set at about 500 or 600 rpm. I will try to slow it down some more but I have had trouble keeping it running at slower idle speed. Tom Sent from my Z932L using Tapatalk

My M220 continues (dieseling) to run after I have shut it down. I have checked the timing. I have run stuff down the intake to clean out the carbon deposits. I am not sure what else I should to eliminate this problem. Any help would be appreciated. Tom Sent from my Z932L using Tapatalk

Greetings from Coldwater

Gentleman read the manuals and the data plates on the dash. Once the transfer case lever under the seat is in the correct position the transfer case is disengaged and therefore has no connection to the transmission. At the point the truck can be safely flat towed without the need to removing...

Place the transfer case lever under the seat in the neutral position. There should be an instruction plate on the dash the has the instructions on towing.

OK never mind that last post. M y fat fingers got things all messed up. Linegodd101. Welcome aboard. Where in Michigan are you located. I am in Coldwater. Also I am the VP for the Great Lakes MVPA. You are always welcome at our events

Welcome to as. Ehetr in michiga

Welcome from Michigan

Thanks Gents I will update when I get it done. We had the truck given to us this summer. When she found out that it was an automatic, she said I can drive that, that is my truck. Then she said I could drive when we are pulling the trailer with the MB and MBT. Sunday she asked me if was...

The windsheild seals are bad in my wifes M220. We wondering what others have done for replacing these seals. Tom