Search results

Thank you for your replay. The hinging test say max. 0.02 inch. I'm fairly under this value (0.008 inches). I know that there are other threads discussing about this, but can be that original driveshafts are unbalanced after 15.000 miles? Or maybe a production failure? Christian

Hello all. I own a M1078 A0 from 1997, with the "D" sign on the VIN plate. The truck have now 15.000 miles on (7.000 by me) and have not really feelable vibrations, except somtimes the unbalanced tires. I have default gears, no high speed gears, but the detroit locker in back axle. All screws...

Hi there! I will make one the next time I'm using it. But please don't expect anything magic, it's quite simple and easy...

Hello. Maybe a leaking tire valve? I had the same, but that was another story. I got a ECU from a M1088 with 90psi highway pressure. That was too much for 1 of the tire valve and vent out until tire was flat. Christian

Hello! Thank you Sir. The problem is that the hole sistem is not single tire controlled, but there's only 1 pressure sensor under the dash. So if you want to control every single tire you need to rebuild all the system. In that chase I would think about using the hydraulik pistons on front axle...

Thank you Sir!

Finally got time to make some pictures of the inside: Christian

Great! Thank you sir! Christian

This one: N30252B on TM ...-24P, page 383, item no. 18. Thanks a lot! Christian

For the entire check valve yes, but not for the repair kit... Christian

Hello! Do you have a part number for the repair kit? Thanks! Christian

Yes, they were tied together. I didn't notice about it, I saw it only after I pull them out... ;-)

Here some pictures of a revovery. I didn't be aware that I pull out the truck and the jeep together.

Hello. I have some videos recovering a truck plus 4x4 jeep stucked in mood. I have it only on smartphone, I cand send it to you or post it, as you prefer...

Do you have a link? I cannot find it on web...

But do they had 225 or 290hp? I think there is a lot of diffrence if you keep the original hp and the modified... Christian

Hello! I am thinking about putting on a M1078 with the 3116 engine and 225hp the high speed gears and 3.07 ratio. But I am not sure about the loss of the 20% torque, if it's noticeable and have on steep / sandy terrain a negative impact on handling/performance. Does anyone have experience in...

The CAT code of the 2 o-rings are 4J5477... Bought together with the tube, but after reading this thread I decide to switch to PTFE flexible hose. in my opinion (but I am not a expert) the problem in this tube is the diffrent vibration produced from engine and air compressor. Even more if some...

Yesterday I change the steel pipe with a flexible one. When I loose the upper fitting I saw that the steel pipe was under tension, IMO because if you tight the fitting on the side of the governon the pipe tent to rotate versus the engine. Maybe the mix of tension and vibration is the cause of...