Search results

Did you build your box or buy? Looks great!

https://www.ferromit.com He does WMO distillation too.

Filtermaxx USA

Nice welds.

I need a mag drill. Seems like one could make one.

Where there is a will, there's a way!

Thank you I appreciate the help!

Did you use 3/16 or 1/4" box beams?

Just curious what you paid for the large box beams. I need to plan my budget.

Can you provider more specifics on these shocks? Thank you.

Fork that! I may do that actually.

On a 6x6 you have to get psyched up and prepared for the middle chunk swap. Need solid prep to prevent sudden death by chunk. Large trans jack needed or gantry. Locker will be placed in middle chunk. Have 2 lockers.

Crickets for a reason. Have not done mine yet. The dry run does not require them. More important things were done like: All silicone hoses replaced Radiator flushed Thermostat replaced ALL fluids in engine, trans, diffs with synthetic Driveshafts balanced U Joints replaced AC installed All...

DiverDarrell was his screen name on here.

There was a discussion of starting a fire under the truck a while back : )

I was watching a 4x4 program where they were using a special u joint with twin u joints in the same unit to overcome angulation.

I would say that keeping the grease zerks always greased would likely reduced the wear on the yolks and other parts. I would use synthetic since they tend to be more tacky and are not as likely to get rinsed out.

Everyone was a Newbie themselves once. No one is pre-programmed at the factory. It is a honor to teach. Contrasting opinions are ok if done respectfully.

Silicone blades are not cheap, but well worth it in the long run.

I have not seen the rock hard plastic issue with any of my vehicles. I have however seen the Southern sun destroy rubber blades though. This is why I went to silicone blades. They will outlast rubber ones 10 to 1.