Search results

Those one off parts are golden ! , good job.

I have seen the fusible link going to the 12v firewall block partially burn and still show 12v but not carry full load. You can try running a good size wire direct from the battery to that block, that will eliminate a bad link.

C turbo

When I restored my M38 I purchased my NDCC tired from universal tire, they have the correct tubes and flaps and are familiar with military vehicles. They attend a lot of shows and can deliver them to save shipping.

Of all the cucv starters I have dealt with the only way to tell was if the solenoid was marked with the voltage.

I have some extra radiator pads, they look identical to the cucv radiator pads, typical GM radiator parts.

Installed the pto today, was not too bad of a job. I filled the pto with gear oil last night and drained it out today, thought it would be a good idea to pre lube it. I did not have a gasket so I made one from the back cover of a M151 hand receipt manual, got to keep it GI. I also needed a...

Pulley, Alternator 3020-00-081-9500 P/N 11594815

So today was the day to start prep work for the winch install. The most dreaded part is drilling the 2" hole through the front hull, so I figure go for that first. Inside the hull is a 3" flange welded to the front hull, this is where the winch shaft enters the hull and also where the seal...

I have my own 2 meter repeater on a commercial site, a Motorola Quantar mixed mode, analog and P25 digital. Comes in quite handy and most hams don't have P25 so it's almost like having a private system. You really don't need the extra class license, I just did it to prove to myself I could do it.

Good job, it took me 3 tries to pass my Extra.

Power output seems correct, does it show that it is on frequency ?

Good job, please keep us updated on your progress and would love to see more pictures.

Springs shipped today, look forward to seeing the brake project finished.

PM sent

I'm showing 12259365-1 as boot and 12259365 as the joint.

I live off the power grid, have solar panels, charge controller, MEP-003A and a 24v battery bank as well as a Isuzu 3LB1 8kw diesel as primary. I have the Isuzu wired to run auto through the Magnum control module. When my batteries reach 23.8v my genset auto starts and supplies house power and...

Welcome aboard, although I do not currently own one I have restored 5 mutts, some whole, some half cut and one x cut.

I have a spare set. PM your address and I'll send them out.

Glad to see you are back on board, and good job on the steering repairs.