Search results

This is the solution that worked for me. I live in PR where high humidity and heat is normal. I just remove the lower 6 pin connector and run it for five minutes with the top open since the fans wont work. After it heats up, turn off, plug the connector back in and voila!

Anyone know what these two white plastic knobs are for?

Im glad i lost all the bids i placed for these units. Did they turn out to be fakes?

These people are nuts. They jacked up all genset prices and are gouging due to hurricane season.

Were you able to see my videos?

Ok, here are two videos. One is with the pump finger tight amd the other shows the flow when its loose till i tighten it by hand to finger tight. I have updated the links. https://drive.google.com/file/d/1SqnQGzT3ecKN-_VSwzgrL2lkgsCVWd2a/view?usp=sharing...

I dont have a pressure gauge to test it at this moment but the flow is not enough to start the engine. If i finger tight the metering pumps i do see a gush of fuel coming out every two revolutions but not enough to call it a jet. I removed all the pumps again and reinstalled to make sure the...

Hey guys I have an issue maybe some of you can help me with. My 803a did not want to start and I tracked the problem down to a stuck fuel pump. So i took out all 4 one by one to avoid mixing them and put them back once i made sure the lever and piston moved freely. The issue is I do not get...

Amazon had none available but I did get it off ebay here. https://www.ebay.com/itm/Stove-Bright-6198-High-Temperature-12oz-Aerosol-Can-Stove-Paint-FOREST-GREEN/303162742715?ssPageName=STRK:MEBIDX:IT&_trksid=p2057872.m2749.l2649

Awsome! it would be great if you could upload them.

Did you friend ever get back to you with the correct voltage for the 007b mag pickup?

This is the pump that was on my 002A. Had to rebuild it and got the parts directly from ambac.

My unit is reading .115 vac.

Hi Guy. What voltage am i looking to get at the mag pickup for this 007b? Im looking at the -24p manual but can only find the location diagram.

I know how to check the diodes but was wondering if there was a voltage parameter that I should be looking for.

Im not clear on what values i should be looking for when testing the main gen 1n1190/r diodes.

Ok, I will test those tommorow since I already removed the bell housing to get to the exitor. Thanks again.

A1 diode as in a bad avr board? Where is the main gen diode located?

I temo I removed the diode and tested it. Thats how i got the 10.5 ohms on r16

R16 resistor is showing 10.5 ohms instead of the 3k in the manual. Im going to replace it.