Search results

No such thing. You will need to piece together all the parts you need from the few vendors that have them.

This repair is no fun. After burning off the u bolts from above, I was unable to drive them down and out due to them being completely rusted frozen into the spring seat casting. I ended up buying an entire rear spring assy from someone that was bobbing an A3. Even with those serviceable...

The REB does not interface with the transfer case. If the front driveshaft free spins, then your drive flanges are desplined or possible broken shaft. It’s been many years but I vaguely remember the transfer shift rod needs to pull out more than that in order to shift the transfer into reverse.

Is it possible the previous owner desplined the drive hubs or left off the front driveshaft? The shift tower controls both the hydramatic and moving the transfer case linkage. With the engine off, see if moving the shift lever from neutral to drive to reverse causes the shift rod on the...

The bow corner straps are used when you roll up the sides of the canvas cover, there are buckles attached to the canvas cover that receive the straps and retain the rolled up side.

Yes, HMMWV has the center mount turbocharger and it won't fit: Center mount Turbo M1008 | SteelSoldiers

Did the turbocharger come off a pickup truck or a HMMWV?

Does the battery box cover fit down on top of the 31's????

Looks like the truck has been well cared for and fortunately you have the 11.00R20 tires which are less likely to cause issues compared to old super singles. Where is the truck located? One of us might be able to Uber you from the airport to the truck and assist with any maintenance.

Looking good! Appreciate the accurate markings!

United States of Freight is HIGHLY recommended, but if you go with bubba trucking, make sure they are using a RGN trailer. A drop deck won’t work.

Magnesium wheels came on early M151 Mutt 1/4 ton trucks. People that are restoring these vehicles desire these wheels as the Army started using steel wheels, and these got replaced. I personally don’t think 416s came with those wheels but I was not there in 1961.

Minimum 15 grand. Dumps bring a premium as they usually end up at construction sites.

2900 at 55 mph is roughly what you would see if the 4L80E is in 3rd (direct). Pull codes.

Oh yes, they are notorious for getting pinhole rust holes allowing a troublesome air-fuel mix to get to the engine.

What pressure do you have in the system? If your refrigerant has leaked out, pressure switches will prevent the compressor from coming on.

Look through these TMs for the air brake diagram, will be in a -20 or -34: TM's for the M39 Series 5-ton | SteelSoldiers No clutch brake. Clutch probably needs free play adjustment.

The wrecker body is a transplant from a M108. Engine looks like a transplant from a mil generator set of some type. Looks like some other interesting trucks there too?

Your 6.2 has burned up crankshaft bearings. Time for a GEP 6.5. Or an expensive rebuild of your engine.

Check the connectors coming out of the smart start box for corrosion either on the pins or where the wires are soldered into the pins.