Search results

Hey Guys, Hear Is Todays One Million Dollar Question. Which Font Axle Boot To Buy For A M35A2. Today, While Cleaning My Truck I Notice That My Font Axle Boots Are Ripped. I Have Replaced Them About 4 Time Now From The Day I Bought The Truck. I Have Had BLACK ZIPPER, GOLD ZIPPER ...

Hey Guys, Was just trying to find out what this is (Dearborn Protocol Adapter III Plus CAN Diagnostic (Military Version)). I know what a STE/ICE Tester is and know how it works and what it is used for. Is this similar to that and dose it plug in to a pc. Also if it plug in to a pc what...

Hey any one purchase this turbo kit yet? I have a 6.5 non turbo right now and would like to install one this summer. Also any thought about this kit? https://www.6-5liter.com/hmmwv-turbo-kit/

Hey guys, What rpm should a m998 6.5 non turbo 3 speed idle at and what rpm is red line on that truck too thanks.

Hey Guys, My (M998) is always hard to start with cold engine in colder weather. I have replace all glow plug last year. I have tested the system by connect a amp meter across the batteries and with the glow plug cycling I see a draw around 89 amps. Also check ohms resistance on all glow plug...

Hey Guys, Any one every put Centramatic Wheel Balancer on there M35A2. I have them on my m998 and are a big believer in them. They work great on that vehicle. My M35A2 is on single good years 395/85r20 tires. I was hoping they would remove the shake I get in the wheel at 62MPH when I am...

Hey Guys, Need to replace my Plastic Fan On my M998 6.5 non turbo engine. What is the difference between these two fan i have found. Thanks

Hey Guys, What Is this Tapped Hole for on the Rear Lower Control Arm???

Hey guys, Looking for a new Steering wheel and wanted to know how many types were used and where they all the same size??? I have found two types and the one I have is 20inch OD and I have read that some were 18inch OD. Also any good suggestions to prevent them from cracking over time???

Hey Guys, New to MTVR. But was trying to find out do MTVR have air locker or open diffs in there axles.

Hello all, Have a small question, replaced all my Brakes last year drums, pads and new brake fluid (DOT 5) Purple stuff and they worked great after that. But now this year when I let the truck sit for 2 day or so the brakes Squeaky when you first use them, after that this is no noise. I am...

Hey Guys, Was removing the radiator and thermostat today and notice that my intake manifold is a little mess up inside. Was this a bad casting from the factory or is this rusted out. Should I be worried about this??? Attached are some picture.

Hey guys, Is there a Cross Reference Number for Brake pads & Brake rotor for a stock 6.5L M998. From (Autozone ,Napa, advance auto, pep boys,.......). If not where is the best place to get pads & rotor for the M998. Thanks

Hey Guys, What is the protection Level (1-9) of clear Humvee 3/8" bullet Resistant Glass for a x door. Also is the glass from (federalmilitaryparts) real Ballistic X-door Glass. https://www.federalmilitaryparts.com/products/4-clear-humvee-bullet-resistant-replacement-window-glass-m998-hmmwv

Hey Guys, What is the armor louvers called on these front door & why is it never found on the rears door.

Hey Guys, What should the brake pedal travel be on a m35a2 with new brake pads. The brake pedal travel about 3" to (Max Brakes Lock Up All 6).When pressed all the way down the pedal is even high to the accelerator pedal. If I measure from the floor to the top of the pedal when not pressed I...

Hey Guys, Went out today with one of my m35a2 and the brakes got supper hot about 400F. Hub where cold as ice and the air Temp is about 35F today, there snow on the ground. Just did bakes on it last weekend. Brakes are adjusted right when I jack up the truck the wheels spin freely no drag...

Hey Guys, How can you tell if you have a faulty injector pump. What are some symptoms and is there away to check a injector pump when it is one the truck. (Example: can you put a high pressure fuel gauge Hydraulic Head)

Hey Guys, Today I was working on my buddy's M35a2 Rear axles and I notice when I spin one tire the other spin in the opposite direction and I cant hold one side when you spin the other side. I thought the axle where open diff, There for I thought you could hold one tire on one side when some...

Hey guys, So today I finally fired up my m35a2 and toke her for a drive and she blows white smoke. The truck has been sitting since May. Been redoing all the axle (brakes, seals & bearings) and putting in arb air locker in all of them. The motor ran for a go Hour today, It ran great no lose...