Search results

This will be my first time bidding on gov liquiidation and I'm looking at purchasing a truck in another state. I see on gov liquidation that you are supposed to pay tax in the state where you purchase the vehicle. Does that mean that when I license the truck in MN I have to pay sales tax...

I'm in the process of adjusting the brakes on my M812 and ran into a problem on my first wheel. I'm currently working on the drivers steer tire. I'm going by the manual for adjustment procedure and everything is going well until I get to the adjustment bolt on the upper left side/the bolt...

I'm in the process of replacing my steering knuckle boot. After taking off the old boot and the boot/knuckle protector plate on the front of the axle I put some grease in the bottom grease zerk under the axle to see where exactly the grease from this zerk goes into the assy. At first it just...

After taking the engine drive pulley bracket setup off to ease with belt replacement I notice that the unit doesn't spin as freely as I would like and makes some noise. It looks like the old grease zerk was ornamental only as it took a good 20 pumps of grease before the new grease started to...

Got the radiator out and have all of the belts off with the exception of the water pump belt. I don't see any adjustment to loosen this belt up? I walked the old belt off by using a screwdriver and wrenching the engine over. The new belt is tighter and will not install this way. Do I have to...

2nd question asking about air shift for the transfer case located on top of the transmission. My truck is currently blowing air out of the vent tube while in neutral. When I put the truck in reverse the air leaks go away. I did spray a soapy water spray over the assy. and I had bubbles...

I'm in the process of replacing all of my accessary drive belts and was wondering if any of you have the part numbers for these belts so I can purchase some new ones at Napa, Car Quest, etc. Thanks again, Andy

On my M812 all of the marker lights (back & side) work except the front two which are part of the blackout/turnsignal assy. When I use my 3 lever light switch to turn on the marker lights none of the marker lights come on. When I flip the switch to head light operation the head lights and...