Search results

I used a big pipe wrench. Biggest one harbor freight sells with 20% coupon. Soak with pb blaster or your favorite penetrating oil.

Yes, the metal bows for a m101 & m105 can be interchanged as there are 2 different set of holes to adjust width.

Just fyi that the first ones made were plain steel/iron that rust badly. 2nd generation are coated yellow zinc? Learned that when I replaced mine. I also coated threads with anti seeze

You can get a higher rating and already is set up for a dual lunette on the xm1073 series. No ball mount but lower to ground than the m1061 draw bar. Bigger cousin to the m1061. I know of a member in La that has one for sale but that is clear across the world from you. https://uttwi.com/m1073.htm

I just go around hook and use a taut line hitch. 2 loops in and one out. Holds tight and does not slip.

Main cage requires brackets. Suggest you read instructions for the kit. I think they are also in the tm's. Front cage depends on winch set up or no winch.

Looks like a forward air control truck. They have that small door on the clamshell for a pull out antenna slide mount that holds the large harris base with the tilt adapter and the the 4 part mast. See if there are holes on the top of the fender inside where that small door is located...

There are many options depending on which radio and era. The most commonly seen are the AS3900/VRC which is the wider fiberglass 2 piece than the single steel mast. Both the AS3900 & AS3916 are for the sincgars radio families. The later models are typically harris/ shakespeare units. The mount...

If they are the metal bows, then yes they will fit both trailers as they have 2 sets of holes to bolt up to the corners. Corners are the same for both trailers. The vertical stakes are different.

welcome to the madness :-)

Now that I take a closer look on a larger monitor, the extra port appears to be the threaded section where the drain/air bleed petcock is and most probably a m939 heater core.

Looks like some. Type of heater core. Does it have a drain petcock?

Just a quick update. The repaired pins are working great! I recently switched Boy Scout Councils and moved the trailer to my new assignment as Avondale Scout Reservation. I installed the 2 baskets from the laundry trailer set up Butch had given me on the top frame. For this camp, I put the...

the rear bracket on the c crossmember? that the pioneer rack slips into has elongated holes and some adjustment. Might need to play with that bracket and possibly adjust the holes?

It is a huge 28mb file on the cucv electrical and your email or browser might be chocking on it. Not sure on what type of connection you have but it is working.

The other pictures confirms to me that is a low speed flight line trailer by the tongue design and the rims and not an on road use trailer. Thanks for sharing.

These are USMC specific. Saw one of these in New Orleans Check out: https://www.steelsoldiers.com/showthread.php?62008-quot-MV-Spotted-quot-thread&p=1835875&highlight=marine#post1835875 Look around post 4559-4571

Thank you for serving your community!

That is not a m116 or m1101 family. Special purpose built I suspect. What kind of suspension and axle?

There is a tool to remove the pulley as well as a separate tool to install. Any parts store will have them in their loaner tools like autozone, O'reilly, advance, and better Napa's. Does not cost anything to use these tools just a deposit till return. Pulley typically installed flush with the...