Search results

But just barely.

Nice. I'm really liking the two classics in front of the 936, but that just might be because I already have a 936.

That is a constant velocity (CV) joint like what is on modern front-wheel drive cars and 4x4s with independent front suspension. It definitely needs a boot, more so than a U-joint.

What, you sold the shelter after CARNAC dragged it halfway across the country for you? What, you sold the trailer after I dragged it halfway across Texas for you?

Brakes and breaks, wishing good all around.

If the wrench is parallel to the ground and your weight is centered on the mark, you are at 450 ft./lbs. You can keep reindexing the wrench as you approach the final torque so the wrench handle is close to level. Breakaway torque would be a concern whether using this technique or using a high...

Why don't you just use your body weight on a long wrench. If you divide your body weight into 450 ft./lbs., you get the distance in feet from the center of the bolt/stud/nut to where you should place your weight. Example: 200 lb. weight into 450 is 2.25 feet so 200 lbs. on a wrench (cheater...

Now you just have to crawl under the truck and adjust the cable so it always lands in the sweet spot when in neutral. Pull a cotter pin, pull a clevis pin, adjust length to suit, reassemble in reverse order.

That very one indeed.

I have found that some trucks need the transmission shifter cable adjusted to ensure power gets through the switch on the shifter. It sounds like the problem you are experiencing. The indicator on the shifter should line up exactly with the "N" when in neutral or power will not be fed to the...

X2 on the stock location. Easier to got off and on than in the bed.

Just a quick guess...the 12V incandescent will smoke immediately. (O.K. not so much a guess as an I know) I believe someone was selling 24v incandescent clearance lights in the classifieds. You can also get replacement 24v bulbs to replace the 12v bulbs in any incandescent fixture.

Don't give up on the original batteries too quickly. I have had several sets come back from the dead with long slow charging sessions. However, as has been stated, do not try running on a set of dead batteries from the get-go or risk the alternator. Frequently, the failure mode for these...

You need omnivolt LEDs (10 to 32 volts usually), or 24 volt lights, two identical 12 volt lights in series, or a separate 12 volt power system. All of this has been discussed on several threads. There are several vendors in the for sale section selling stuff to make any of these options...

Some have found out (the hard way) that rebuilt trucks aren't all that. Shoddy work seems to be quite prevalent on more recent rebuilds. So my advice is to not get too fired up about paying a premium price on something just because it has new paint and low hours/miles due to a rebuild. You can...

Yes, that's the one. And no, it is not an M35A2. But I say 'close enough for government work" and really cool.

I second the above but suggest to also show her (and the class) the old fording video.

I would like to mention that one of the things I appreciate about this website is the relatively uncluttered pages, as in not requiring much time to fully load a page. When accessing through a dialup connection, this is a major concern. Now, if all you get is a suggestion to check the TM's, then...

I installed one of the ones I bought by not in an MV. It is in my truck camper. (Please note that these radios ARE NOT cd players) The radio is really compact and light. It is about half as deep and half as heavy as the cd player radio it replaced. It works well as far as I can tell by using it...

Hey Matt, I know that the wire numbers and functions are the same between the deuce and your truck. If repairing the harness, use the deuce wiring diagram.