Search results

Does a 3053-a really need GL - 1 and not GL-5. Will Gl-5 80-W90 hurt it. My main problem is that I cannot get 80-W90 GL-1 anywhere around Springfield,Mo. Thanks.

I would like to put a mechanical oil pressure gauge on my LDT-465-1D . Where would be the best place to plumb it into the engine. Thanks.

In the next 2 weeks or so I will be crankin the truck over for the first time in 11 months. I got a new inline fuel filter from o'reilys( part # e8131 by Airtex) and a new water seperator filter to replace the old primary(part # 33418 by WIX). I also replaced the copper fuel line with 3/8...

Hey guys. I need to know what kind and size of fitting that connects the fuel supply line to the bottom male fitting on the IP. I belive its a flare but cannot find it locally.

On my bobbed duece ive got 46 inch xml Michelin tires. How tire pressure should i use. (when tires are cold).

This morning I found a puddle of coolant under my truck. Turns out it was coming from the intake gasket at the #3 cylinder. Where can I get an intake gasket by itself and not in a set. Saturn wants $125 for a complete engine set. Thanks.

I have a source for it but if I filtered crude oil and mixed it with some gas or diesel , could it harm my Ldt-465-1d?

This subject may have been covered in the past, but I am curious about how to install boost and pyro gauges on my 1966 Bobbed M109 with the White LDT-465-1D. Thanks.

Within the next month or so, I will be starting my LDT-465-1d for the first time since last summer. It has been out of the truck so the rear main seal could be replaced. I would like to know what I could do to minimize possible damage to bearings, etc.. Thanks for the help. This site has been...

I just got done putting the engine back in my 66 Kaiser M109. I need to know where all the starter related electrical goes and how it hooks up to the the starter solenoid. A diagram would help if possible. Thanks for your help!!

On my 66' kaiser m109 does the airshift need anything electronic besides the light that shows it to be engaged? Is the dash switch electronic or mechanical? thanks for your help

How much grease should i put to the kingpins on my M109? Could i hurt anything by putting too much in?

on the left side of my duece brake air booster there is a brass fitting at a 45 degree angle. Is this a vent? If so where does it go?

i just got on steelsoldiers tonight . i've got a 1966 Kaiser m109 thats been bobbed, axles rebuilt , back hubs flipped, ouverson lockouts, 46 inch xmls on custom wheels , and just got an air-o- matic steering set up in the mail today . these mods are going to make it a really good truck once i...