Search results

No good and worn out. Have to keep an eye on fuel w/ paint stick stirrer. Primitive but only run out of fuel 90% of the time.

Thanks!

It is a predecessor to the CJ-5 Civilian Jeep, here is a link. https://en.wikipedia.org/wiki/Willys_M38A1.

Thanks again deathrowdave for a reply...not sure if I have the coupler between trans output and case input.

Thanks for the info deathrowdave ....good on the M880 sender but need one for a 38A1...wouldn't have one would you? :)

IN

Okay, Thanks for letting me know.

That's what I was thinking too...I do have 2 donor Jeeps, 1 a '48' Cj2-A and the other, only has the body and front and rear axles. Not sure what it was/is originally but a 2 or 3A or MB, GPW. Also looked at both of their front ends, 1, the steering knuckle comes straight out and the other it...

Here a picture of the Driver side axle housing.

Thank you for the quick reply....hadn't thought about that....welding the race in. So I could leave the Pass. side axle assembly, Brake, S. knuckle, R. G. & Pinion all intact and take it to them?

Worked on my front wheel situation yesterday and today. Got it down to just the axle housing end. The bottom axle housing, where the K. P. bearing & race sit , has separated with a 1/2" gap in it. There were pieces of metal where it sits (the gaped area) The metal around the gap looks like...

Today noticed, while Jeep on flat level ground, top of front driver side tire was tilted toward the pass. side tire. My wife even noticed it the other day. Jacked it up and when grabbed tires at 3 & 9 o' clock not much play. 12 to 6 o' clock, the tire immediately collapsed inward at the 6 o'...

In process of removing parts to replace the bearings. Axle nuts were removable by using only my fingers, outer and inner...are they suppose to be, do have manual locking hubs but always torqued inner and outer with axle nut socket on all 4 X 4's I've worked on. Brake hub won't pull off by...

Okay...was searching Kaiser J. Walacks, and then E-bay and were listed as King pin bearings. (E-bay) Thank you for the information.

NDT, would they be available at NAPA? Thanks

Today noticed, while Jeep on flat level ground, top of front driver side tire was tilted toward the pass. side tire. My wife even noticed it the other day. Jacked it up and when grabbed tires at 3 & 9 o' clock not much play. 12 to 6 o' clock, the tire immediately collapsed inward at the 6 o'...

(y)

Good advice....I have everything ......You would need the transmission, clutch, flywheel, bell housing, throw out bearing, clutch linkage, peddle, and all that goes with it. The shift lever. ......... Would be much more problematic to swap out to the manual trans. Thank you for your reply and...

Changed out hinge on the right side and it fixed the problem. If I ever have to do this project again, I'll remove the 3 bolts that hold the Hinge spring assembly (after propping up that side), then the 2 bolts into the hood and then attach new hinge top 2 bolts followed by the 3 that attach...

727 has been leaking fluid and need to deal with it. I have a 4speed from an '84' Dodge pickup with the granny Low. Mine has the 318 and 203 TC. What would be involved to swap the 727 with N435 or 455 ( not sure which it is as I'm typing but it is the granny Low)?