Search results

Does anyone know what TM has info on chaining up a Deuce..? Also, anyone with first hand experience with chaining up a Deuce, what works and what doesn’t..? Thanks, Andy.

Does anyone have a NSN number for the M116 Cover..? Thanks, Andy.

I need a 24 volt voltage regulator for a mep-003. Anyone have a source..? I would imagine that it's the same for both a 002 & 003 and possibly others. The model is fvr-4006. Word of advice. If you know that you have an over voltage problem and the generator you purchased had all of the...

Anyone have a source for MEP fuel pumps..? Thanks, Andy.

I installed a NOS heater in July. At first I had problems but after bleading the fuel line and cleaning the fuel meter/solenoid it started to work. It now refuses to fire. I cleaned it again but still no fire. One thing I can tell it that the fuel solenoid is not clicking as it should...

Anyone here using the 55 gal drum adapter..? How are you venting your 55 gal drum..? Thanks, Andy.

I have a MEP-002, 960lb, that I need transported from Hooks, TX to Oklahoma City. Please IM me.. Thanks, Andy.

Has anyone used anything like this to mount a MEP in a trailer? My MEP-002 shakes the hell out of my 101a2. The trailer also creates much of the noise. Thanks, Andy.

I have 2 A2's that are missing the crank. Can someone post a good image. I haven't been able to find any so Im going to fab my own.. Thanks, Andy..

Anyone have any luck with installing a muffler on a MEP-002a..? Thanks, Andy.

We have several 105's. Some have covers that fit very well and others that came with covers that look a bit too big and the tie down ropes don’t line up quite right... Anyone else have this problem..? Thanks, Andy.

Ok, my plan is to mount a MEP002a in a M101a2 trailer with a deuce fuel tank in front. Install a muffler and route the exhaust toward the rear. I want to roll up the front and back of the cargo cover when running but leave the top and sides on. Does anyone see any issues with that...

Im about to install a Multi-Fuel Heater in my Deuce. Any words of advice, suggestions or warnings..? Thanks, Andy..

Anyone know anything about these..? 6,000 Btu Air Conditioner, Military Surplus, Brand Not Specified at Sportsman's Guide They don't provide a model or NSN... Thanks, Andy..

I have several vinyl cargo covers for trucks and trailers that are servicable but weep/drip water from the top. Has anyopne found something that will seal the vinyl covers and will stay flexable, not crack or yellow..? Thanks, Andy...

Has anyone else had a problem with the air-o-matic pressure regulator venting air? It will drop it below 60lb setting off the low air warning and causing the safety valve to the steering system to trip. I messed with it and it stopped for a few weeks but is doing it again.. Thanks, Andy.

Does anyone know if a rebuild kit is available for wiper motors..? Thanks, Andy..

What is/was the purpose of the M1061A1 5 ton 4 wheel flat bed trailer, anything specific..? Thanks, Andy.

I’m in the middle of installing my kit and have run into 2 problems. 1. The bushing that is supposed to be installed on the shock absorber is too small to fit on my shock. 2. When installing the power cylinder, how do you get the rubber bearing shields to fit into the axel bracket with the...

I need to replace the shutoff valve on the emergency air line. Any suggestions..? Anyone have any info on a replacement..? Thanks, Andy..