Search results

Did you put one on your M1010? If so I would appreciate any information on the parts from GM so that I can put it on mine. Think that it would be much cheaper and easier to get. Tom in TN

Fuel Pump on M1010 Hello to all once again, Have been down for the past 5 or 6 months recovering from surgery and then the weather went bad here in NE TN. Replaced the fuel pump on the M1010 and still no fuel to the filter. Had a retired motor sgt here a week ago and he said that if I had...

We just replaced the fuel pump pushrod (old one was broke in two). Seems that the engine is struggling to turn over now. What would cause this? When the old broken rod was in (we figured out the electrical problems) it turned over rather good. Now is seems to struggle. Tom in TN

Where is the best place to get a fuel pump push rod for the 6.2, M1010 need one, old one was broken in half. Tom in TN

New in TN Welcome aboard, We are in Jonesborough, have an M1010 that we are working on. Have had several problems over the past year after driving it up from AL. Think that I have something wired backwards right now as it kills the batteries the moment I turn the key. In any case, though I...

Its OK, but always hate change.

Tried to charge up the two batteries as well as jumping the front one (worked when the top alternatro fell out on way back from Al.) The gauge inside the dash did not go above the yellow so I suspecth that the charging system is still having problems. I had both alternators checked out and the...

Tried to charge up both batteries today. As soon as the glow plugs started to heat up it seemed that the relay became too hot to touch. Is this normal? Kille the batteries at the same time.

Have a similar problem with my M1010. Drove it home from AL, ran great. Had problems with alternators, bottom one needed repair. Both batteries were checked out and found to be good. Can charge them up and put back into vehicle. Seems to have a fuel problem, listed under that thread. But...

Have a similar problem with my M1010. Drove it home from AL, ran great. Had problems with alternators, bottom one needed repair. Both batteries were checked out and found to be good. Can charge them up and put back into vehicle. Seems to have a fuel problem, listed under that thread. But...

Have a similar problem. Drove it home from AL in the spring and have been working on it (sort of, been rather busy with honey due things) over the summer and now want to get it on the road. replaced the fuel filter and the pressure switch and still seems not to get fuel. Should I break a line...

Put a fresh known good battery in place of the one that has not been charged good. Checked the positions of the light switches and they were ok. Checked the voltage at the glow plug lines and it was 0. Still no lights at all. Think now that there may be fuseable link that feeds the fuse...

will check the light switch positions as soon as I get home today. The engine did crank real good while I had it hooked up to my car with jumpercables. Glow plug light went out after about 45 seconds but still did not start the engine. Will check the glow plug wires too. Thanks for you help

My son is near Statesville and the mother in law is in Morganton. Have a major problem and do not know how to proceed. Had the problem with the front battery not charging. Had a burned out fuseable link. Fixed that the seems now that there is no electric at all, no lights nothing. Starter...

Appreciate it Smokey. What part of SC is Easley in? We have relatives all through NC and could possibly catch a cup of joe some time. Tom

Yep, I agree once you come up on frequency everyone can check out your profile anyway. Planning on putting a screwdriver antenna on my M1010 for the times that I have the HF in it.

Water In Fuel Indicator Thanks Jim, Found the manual version to drain the filter right after posting before. Just waiting for it to stop raining cats and dogs and will go see if it works. Do not mind being hit by the cats but the large dogs tend to hurt. Tom

Side plates Hey Smokeydod, made it home to TN from south AL yesterday. How thick is the aluminum plates? Would probably be just as easy to pick up some aluminum locally and fabricate them. Thanks Tom

Water in fuel indicator On the same line I have a good question. Can the water in fuel light come on for any other reason besides water in the fuel? We ran my 1010 about half way from Alabama to TN running two tanks of fuel through it and the water in fuel light came on. Do not think that...

Not the bottom of the drivers door. The big red cross and cadeusis that are on the sides, back and top. Sorry