Search results

If your looking for cheap horsepower why not advance the pump and turn up your pump? As far as I know the only difference between a marine injector and stock is a higher pop rating and that will give you a crappy idle. May be ok for a M1008 screaming down the highway though.

Where is it?

I think you should get a 20 dollar meter and start probing and read the FAQ section.

Yep I'm with this guy. I would buy some new 6.5 injectors (bosch) and put on the 6.5 turbo. It will be almost the same set up I'm running.

What did you not understand about that post its pretty much straight forward? lol

thanks guys

mine does the same its the detroit in the rear. makes quite a racket and wheel hop.

Went to start my M1008. It is pretty cold today. I have a bypassed GPC with push button. I push it for 10 sec then tap the pedal then turn the key. After it starts I push it in twice for 5 secs. When I was pushing it in it would make a screaching sound. My m1009 does the same. but i think it was...

Can You post more pictures and all of the info about the truck? IIRC it still uses the gm alts and is still 24v.

Did you buy that from him?

No, but I got a nice picture for you Danny :: CIMG1277.jpg picture by tabi524 - Photobucket WARWAG Can you give us some info on your engine? She sure sounded nice. I think it is a 6.2 New Banks kit dumped out before the tire no muffler, rebuilt injection pump, new 6.5 injectors and new...

If you had a 24 volt trickle charger hooker up at terminal block would that work with the isolated grounds?

Here is a video from a truck pull in CT. It was just shy of a full pull. So far I have Banks sidewinder rebuilt IP turned up 6.5 injectors

1)If you turn on your hazzards do all light blink like they should? 2)And what about brake lights do you have those? 3)When you use your turn signal both left and right just lights up but does not flash?

I really think you should try to get your trailer back or rent a "equipment" trailer for the day. You could prob get one for under 100 bucks. I think that would be a lot less of an hassle. and safer.

Change the seal. Its prob like 10 bucks

It is the Frame differences, axles and springs. that gives more lift. not fenders

Hummer rims are 9 inches, both rims will work. I have hummer rims and they work fine, so thats why I said 10"

I would go with the 10" ones.

Do both gen 1 and 2 flash when you turn the key? If not replace/ clean bulbs. you need those to work or they will not charge your battery