Search results

Welcome to the SS forums!!

It may be advantageous to source another OM617 With a pump mod and a good Holset turbo I should see around 170HP which would be enough. The OM617 will do 230HP with a 7.5mm IP, 7CM Holset turbo and an intercooler but an otherwise stock engine. One would need to be careful though with a drive...

All the VW engines that looked like candidates are significantly low on power.

Then it is likely ether the lamp is not getting power from the inst. panel of the lamp is bad.

What would the advantage be?

I was reading about some guy trying to mate a VW to the 404, he was trying to hand make an adapter as there are none available. This would be difficult given the design of the 404 bell housing. I think with the lack of an adapter a MB engine would be the most likely candidate, like GM and others...

Actually I see two salvage vehicle at auction in TX with the OM617 at this time, I may just get one and see if it is worth using. Although I would REALLY like to get away from IDI, they are certainly the dogs of the diesel world.

One problem is 99% of key switches cannot handle the massive reverse EMF from the starter solenoid and arc internally, this for sure has caused the destruction of many starters and very likely some EESS boxes. Even switches that are made for 24V big trucks only control a small relay that is...

There may even be some viable gas engines

I would be surprised if it only shifts into 2nd and there are no codes, other than the continuous code 12, did you disconnect the batteries before retrieving the codes?

Thanks, I was thinking of another MB diesel that would bolt up to the bell housing, seems doubtful I would find a Cummins/MB adapter and there is no choice but to use the original bell housing. (or in my case a copy of the Unimog 411 bell housing that had the OM636 4 cylinder diesel engine) Now...

You need to read the codes on the transmission TCM to start with to troubleshoot the transmission.

Wires #75 are for the brake lights, they have nothing to do with the brake warning lamp Unplug the wire from the brake equalizer and see if the light goes out. The brake warning light is only connected to the parking brake switch and the brake equalizer. The equalizer is the aluminum block next...

If you stop and pee in Papalote they will arrest you, there are no businesses :ROFLMAO: In fact in Bee County if you are walking down or stopped on the highway the cops will check you out, not allot going on around here....

I have a 404 that I re-powered in the early 90s with an OM617 5 cylinder turbo diesel. That engine needs work so I am wondering if there are any other viable options now?

This will also let you see if any IP lines are not getting any fuel, you will not be able to tell if there is enough pressure to fire the injector but you should see similar results as far as how much fuel comes of of each line. If it has always had the "mis" you might want to make sure all the...

On the brake switch, pull the wire from the brake equalizer and ground it to see if the light comes on.

You can disassemble an old battery

Maybe, maybe not most of those locations have US basses and all those countries use the HMMWV

I do not think so.