Search results

The @cucvrus is TOP

yes,you told me that and it helped me a lot to start my m1009 after 10 years stop

Exactly, it was easier/cheaper for them to make a manual drive, than to install. a new glow plug controller board. It is a very common process, do not be alarmed

the empty plug is for the glow plug controller board. You have the spark plug relay in the firewall to the right of the one that the horn was connected to, it is identical

it is brand new compared to the cucv in the chassis that they paid 2500, for my taste the line is more beautiful until 1991,

it's crazy!!!! They have paid almost triple the starting offer, for an empty shell...

this is similar https://www.dieselplace.com/threads/fuel-pouring-out-water-drain-when-cranking.713762/page-3

Thanks

Do you have a reference number for the O-ring? my problem was similiar, I have the series filter bypassed with a universal jumper to be able to start

Hello, could you be more precise? that fuel leak that you say, when did you start to start fuel flowing through the lower left part of the filter? do you have a picture of the board? I have a problem with the fuel filter, @cucvrush helped me start the truck, the glow plugs, purge the circuit...

Thanks

great welding job, are you welding with an electric wire welder? What intensity do you put on it so as not to pierce the sheet?

I finally start, it is alive, thank you very much cucvrus, without your indications and advice it would not have been possible, these days I upload update, I had a lot of work

beatifulllllllllllllll!!

hello guys, excuse me that I have the thread a little stopped, but I am overflowing with work, there are interesting updates, these days I upload progress

great job, like all the ones you do

there is no reputable ip rebuilder in your area?

It has been a difficult few days and we have not had time for much, pieces were arriving from rockauto, so we got to work. The temperature sensor that controls the glow plug was changed, as well as its connector and a universal one was put on, both were 40 years old, they are not very expensive...

we continue with the m1009. After installing the new glow plugs, we reinstalled everything in its place, the wheel arch, batteries ..... we checked that 12v reaches the pink cable of the IP, I followed the instructions that @cucvrus told me we give you to start and the engine turns but the car...

If you are looking for a starter, this is the one you need, I read the opinions and consult the TM and they coincide with the serial number, if memory does not fail me it is one of the last since there were two types of starter, some more square cylindrical and this one, but this one is fit for...