Search results

Here's how it looks on my 4/94. As you can see, the mounts for the loader are farther out than the little triangles, and a lot stouter.

Another "Ouch!" But I know I can make them for much less. Especially now that I have the measurements, thanks to you.

Ouch! That's about four times more than it costs to do it yourself. Or maybe about the same cost if you need to buy a good MIG welder, too, which is reusable.

It did make sense...except, I don't know if the claw setup is strong enough for loader use. On my 4/94 the two systems are completely separate, bolted on to the same frame obviously.

Those are not what you need to mount a SEE loader, if I understand this even halfway correctly. What you need has two large pins at the top and two blocks with holes for bolts at the bottom.

I haven't measured, or tried anything yet, but it sure looks like what's on the front of my "new" MB4/94 has the FLU style mounts bolted on there in addition to the plate with the triangles. For the quick tach plate conversion I used a setup from palletforks.com.

If you find two of them, please let me know. I could use a partial loader.

I wouldn't spend any time or money on one more of those. But if you insist, I do have a few left over.

I recently got an MB4/94 with crawler gears. They're wonderful. Even being in only the working gear range is much better than the SEE's gearing. If the SEE went that much slower, the snow blower would work a lot better. I should start looking for those claws, too, if I end up mounting the snow...

Unless the backhoe is being used , there should be no reason to latch it. Gravity will be more than enough to keep it there. Of course, I forget if using it was part of the plan.

I would've gutted all the front axle stuff, and they probably did. Tire speed ratings? That's for sissies. If you're still worried, use tight snow chains to keep the tread attached to the carcass.

Yes, please do. I don't need the bucket itself, but most of the loader assembly.

For those of you who like driving your SEE on the road (Courtesy of General Hood). https://www.facebook.com/MiningMishaps/videos/332211061383758/?sfnsn=mo&extid=fnF6TdY5YCDHcRGb&d=n&vh=e

Yeah, there are a few of you that I can see not mind having to pay that. Again, I lucked out.

Ouch, $700. I am so grateful for having been able to avoid rodent damage, my cats, and General Hood's schematics.

Hate to tell you, but that new switch is still in its box...somewhere. On the positive side, as I recall that switch can be replaced without having to raise the cab, according to some thread here.

If I remember correctly, I had one that misbehaved. Sprayed some lube down there and it has worked since. That's not consistent with my luck, by the way.

You should be able to either "tow" the backhoe backwards, or the FLU forwards.

Yeah, it sure looks new. Interesting that it never even got painted. Now the enemy can see you drilling away...as if they couldn't hear it.

Nice! I removed all my stuff almost instantly. It's a lot of extra weight. Now there's room for chains, straps, various tools, and some fluid.