Search results

https://www.classicindustries.com/product/all-years/chevrolet/nova/parts/371978.html?gclid=EAIaIQobChMIrtDons7a5gIVgYbACh2hlQvdEAQYByABEgJ9TvD_BwE Sometimes you ask the questions and you also have to answer them. Here is the much sought after part. Now once I buy them the barn will reveal a...

I would start by seeing if it is getting fuel to the out side line of the filter. If it were a truck brought to me I would start by removing everything that was not original. And from there I would trace the fuel lines. I would check them for leaks. No really I don't know where I would start on...

I would lube the fast idle adjustment and you can adjust the screw. That is what I am assuming you are calling the cold idle. Be Safe. Happy New Year.

Sezzo I may entertain that thought. I think it is a great idea to just touch up the M1009 and fill in the paint as needed. It sure would look great and it would be one of the few I have ever seen with the original GM paint. And FYI. The factory GM paint is NOT CARC. But it looks great. The rear...

OK. I am NOT sure how to write on the post after the pictures. But I done a lot of work in my barn during the past week. I have a lot more to go. Anyone have a source for Non-Vented CUCV coolant recovery tank? And looking at the pictures of Red Riding Hood. If I had it to do over again I would...

Sezzo I have been emailing you from rengle523@comcast.net and they are coming back as undeliverable. Just wanted to share some pictures.

New cable. Where did you get a new cable? Is it a Genuine GM Cable. I heard of these problems with new aftermarket cables. Lay them side by side and compare. I think that may be where the problem is. Good Luck.

This is the first time in 20 years that I have everything in my center bay put away and the entire bay swept clean. I have been working in the barn all week cleaning, organizing and sorting thru parts. I have all the body parts on the second floor and neatly stored. I scrapped a few body parts...

Hard to tell from afar. Try and disconnect the throttle cable and start it. Does the throttle shaft return freely and open freely. Was it dropped and has a slight bend to it? How does it act with the throttle cable disconnected? Report back. Is this the first pump you ever changed? Diesel Care...

I never seen anything under there that needed replaced as a standard maintenance item. If the engine is running good I would just replace the valve cover gaskets. And I would do it with gaskets or with The Right Stuff from Permatex. Either way works. Getting it very clean and dry is key to good...

I am not sure what you would be looking for under the rocker covers. But if they are not leaking I would let them alone. When you have the intake off may I suggest you drain the cooling system and service the coolant manifold gaskets and the entire cooling system. Have the radiator checked and...

That will do it for sure. Good does not always triumph over evil. Eventually, no one will make anything because of it. Which leads to my last point, trust. Trust can be granted by others outright but is often earned over time. Once you have proven that you can be trusted, you normally have won...

I found one of the small M1010 placards in my hoard. White with RED snake on stick and OD Green on the other side. Been there a long time. I will take a picture next time out. Camera was dead while I was working. Merry Christmas. Be Safe.

With the oil cap off at idle it will vent crankcase gases. Just pick up the idle a bit and it should be gone. Try that. Merry Christmas. Be Safe.