Search results

This looks like a good Allison code manual. Code list begins on page 25. Found on this webpage. Good luck—

Check out Western Ranger on Youtube. He is @Gunny 0369 here: Beautiful, creative, capable rigs with slide outs—

We like your build, using the top rail to add your floor joists is quite beautiful, you extended the rails rearward, right? How far does your build hang off the back end? Perhaps we have been using a 5x9 trailer so long a 14' floor layout looks huge on our garage floor. We may not need as...

Sounds a lot better than a 1949-1970 Cadillac—

General I would love to see a photograph of your rig. Do you, have you, will you share?

Not your question: As we refurbish our cab and chassis for a habitat we fail to see the reasoning for relocating the ABS, AoH reservoir, AoH controller and hand pump, ether bottle and controller, and tire crane with spare to gain about 8" of space. Moving all that is a lot of work and design...

It would be interesting to see a video of the OEM bags to understand the difference between them—

Success: added a new injection sensor and she fired right up. A little rough at first, not holding as close to desired injector pressures as I thought she should in the step test. Though after a warming her up and checking all the fluids and spots for leaks took her on a nice 30 mile loop with...

ummm. The box under the M-43 label behind the cab is the ABS controller, the M-43 mounts atop that steel mount, not below it. The chemical equipment is all removed before exiting military service—

New fuel line from tank, new primer/fuel separator, new line to lift pump, old line to primary, fuel at tee after primary. You can hear fuel return to tank when pumping a hand primer. Primer stays hard until after cranking, still firm, just not hard. Maybe the pressure valve at the rear of...

So, "...injectors are not fired until..." pressure is sufficient. I wonder if we just replaced a pump that needed a new sensor—

Good question. I don't know, the reman came with a new actuator, the only thing in the fuel system not replaced is sensor and injectors. @GeneralDisorder likely does; the pressure is controlled by the ECM—

Failure: Reman HEU installedI, CAT ET still reading less than 290# at crank. No start. Wondering if I should have replaced sensor, too? Batteries weak, charging them overnight while looking for next steps—

Thank you. I have a hard time knowing what comes with a group and what bits I need to save or order—

Right. You have to pull the knobs. The three are screwed on to the pull rods. You may need a pair of pliers to hold the rods from turning. The fan control just pulls off and slides back on—

And a new solenoid. Also, keep the gear, washer bolt; and small hex bolt on the side off the core?

We just pulled our HEUI pump yesterday and I had to pull the fuel pump cover to get her out in two pieces. I just noticed today that your photos show the same cover off of your removed HEUI pump. Did you 'have' to remove that cover on the way out and what about on way back in?

The bolts that hold the cabin heater in place are accessed from outside. Remove the grill and you'll see them above the radiator on the cabin floor. To remove the cabin heater you have to dismount the parking brake manifold and knobs, and disconnect the water lines, too. Power runs from the...

We just pulled our HUEI pump today. What a tetris game to get it out of that space. I finally pulled the cover from the fuel pump where the fuel lines attach and took her out in pieces. I see you removed more of the wiring than I did. Like separating the block connection to the injectors and...

I have been wondering how a 7JZ to another 7JZ could be a 3126 to a C7. Putting his serial numbers 7JZ00594 and 7JZ06815 in CAT SIS finds a 3126, not a C7—