Search results

Try holding for 15 seconds. Jerry

must be

what took 110 volts of DC and could run on 250 watts? :?:

Good looking unit. Good luck! Jerry [thumbzup][thumbzup]

PM sent. Jerry

I tried. Build a shed or dog-house type enclosure so you can go in or tip it back. ASK complicates maintenance. Jerry :grd::grd:

Sorry Ike, but he asked about a MEP-002a. I wasn't presuming to be all-inclusive. Jerry :grd::grd:

derf Agree. It does not need to be complex so long as the solution is simple, but I sure appreciate the experts when things get complex. Jerry :grd::grd:

NEVER ground L3!!!! It is a live terminal! Your ground is L Zero regardless of hook up. If you want 120/240 simply hook up L one and L three and send ground and neutral to L zero and you have house power. No need to complicate it unless you are connecting to your house power panel, if so...

Once on the opposite side of a door or wall, it is a lower-pitched hum than a high-pitched 3600 rpm unit, gas or diesel. Not aggravating. When i have my units running underneath the deck and the upstairs patio door is shut, my wife doesn't notice it. we live on the water and Pat is used to...

Am back from Alaska...fabulous Bucket List trip/cruise! All GL sites I've been to will let you carry a socket wrench with an extension and a 5/8" socket (if not a whole set) to inspect a generator. Use the 5/8 to turn the fan drive bolt clockwise and counter-clockwise (you won't hurt the...

If there were no shims, you need no shims. The shims go with the engine block, not the IP. (This assumes the previous "mechanic" did not remove shims from the block.) Of the 13 engines I've toyed with so far, only 2 had any shims, so they are not common, in my opinion. I may be able to help...

Not to advertise, but I may be able to help with starters, etc. Jerry

Jim, Awesome! I may make the drive. Jerry

Joe, Head is 20-25 cents a pound whole here. The gen head is classified as an electric motor unless you retrieve the copper windings and sell them separately as scrap copper. I did it with two of my parts units. Salvaging the copper is a PITA. Jerry

I use HH. Jerry

Grega, Glad you found the hose. Was on an Alaska cruise when you posted, otherwise would have offered you one of mine. Jerry :grd::grd:

Good advice Tom and Chris Jerry:beer:

UPDATE: Smart folks here. I got tunnel vision focusing on air leak. Harleyd315 (Chris)suggested a brilliant way to eliminate air as a problem. I modified his suggestion a bit but still rigged fuel supply to a known good generator It still produced same results. I was going nuts chasing an...

Yes I have a pop tester and will retest injectors if the air leak testing doesn't pan out. Thanks to all. Jerry