Search results

my harness is shot for the preheater almost all the wiring is frayed or bare.

Soo im having a little bit f a problem trying to tack down the harness for my preheater. I found a site that has it but they only do buk sales and at least $500 minimum so does anyone know where i can find one. nsn 6150-00-119-3919 fsn 2990001193919 This is the harness that connects the...

Ok so i just switched around the wires as per dieselbobs suggestion. So I now have power in the cab lights, buzzer ect. all work. Now my problem is my starter wont engage no clicking nothing at all when i first started all thi when i hooked up the batt cables there was a loud pop. Any...

so u think i should go ahead an hook to the starter lug and then connect to the bottom of relay. Any ideas where i can find a heater harness mine is toast. Just left on a mini vacation with the wife so i will dig more into this on tues when i get back. The more info i have for then the better...

Here are some pics the lrg wire is #2 the smaller #10 where do they hook up also any ideas where i can get the wiring for the preheater. Looks like it is a seperate piece and the harness hooks into it. Found where the temp goes was a long day yesterday still need to find a home for these 3...

Just installed a new front wiring harness on my deuce i ordered from odiron nsn NSN 2590-01-016-3187. Issue im having is according to the tm 9-2320-209-20-2-2 wire # 33 and 55 go to the temp sending unit and the pre heater. Cant find on my m35 where they plug into on top of...

Just repalced the trannsmission bearing retainer cap not fun but worth doing for the knowledge and the rest is in the pics.

It goes into the transfer case drops down to here for a swivel point not really sure the correct name though. Need to find a replacement one for myself noticed the top hole on mine is wallowed out. Ill see if i can get a better pi tommorrow of it.

here are some pics of what i found when i finally got it off. Thought only one ear was broke guess i was wrong

Sounds like a bit of ingenuity ill give it a try tomorrow and see what i can do. Thanks for the idea ill let you know how it turns out.

I did pull the cotter pin out its is the nut that i can not get off all im doing is turning the whole setup not breaking it loose. Any ideas on how to keep it from spinning.

Hello have a question looked through the search couldnt find anything so here i go. I noticed the rear bearing retainer on my 66 kaiser m35a2 was cracked more like on of the ears is completly broke off. Anyways took off the jack shaft and all other pieces in the way but now cant get the yoke...

Had napa truck shop do mine used the bag of beads got 3k on them so far no issues.

i agree with just using the front battery i use mind all the time also for jumping an i also run my warn 15k winch off it being 12v.

Like everyone else says welcome and get a good hold on your wallet the "od" fever gets expensive when filling in the want list.

Only one way to find out if you sell it youll just end up kicking yourself in the but over it.

looks good

Very nice would like to find one for myself.

Dont feel bad we had a welder in the shop go full bore wide open if it wasnt for one of the guys it would of blown to. They took the fuel filter off and it still kept goin had to smother it out with the intake.

Next time be ready with a piece of plywood to put over the intake will cut the air to motor killin it. Also cut the fuel supply to it you sir just had a runaway. When i first got mine hadnt run in two yrs was waiting for this to happen but thankfully never did. Glad no one got hurt oh yea one...